How to Reset the Change Engine Oil Message The Aztek uses the GM Oil Life System to calculate when to change your engine oil and filter based on vehicle use. It is widely thought to determine oil life by counting engine revolutions. While there is much debate about the merits of such a system as a basis for determining when to change engine oil, the system should be reset after each oil change to ensure that the CHANGE ENGINE OIL message does not appear inappropriately. There are two procedures for resetting the system, one for Aztek's with a DIC (Driver Information Center) and one for Aztek's without a DIC. PROCEDURE 1: Aztek's with a DIC 1. Turn the ignition to ON with the engine off. 2. Press the MODE button until the DIC reads "OIL LIFE LEFT/HOLD SET TO RESET" 3. Press and hold the SET button until 100% is displayed. You will hear three chimes and the CHANGE ENGINE OIL message (if illuminated) will go off. Repeat this procedure if the CHANGE ENGINE OIL message comes back on. PROCEDURE 2: Aztek's without a DIC 1. Turn the ignition to ON with the engine off. 2. Fully push and release the accelerator pedal slowly three times within five seconds. 3. Turn the key to OFF. If the CHANGE ENGINE OIL message continues to be illuminated, repeat the procedure.
Change your oil/filter and reset the light.
There is no code associated with the "Change Oil" light like there is with the "Service Engine Soon" light.
The check engine light has nothing to do with changing the oil. To turn off the light, clear the PCM code using a code reader or scan tool.
Change your oil...
You change the oil.
How do you turn off the change oil light on a Chevysilverado 2002
Warning lights come on when there is an issue. A Oil change light with turn off when an oil change has taken place.
Change the oil.
Change the oil.
If the change oil light comes on, then a person needs to change their oil. If a person changes their oil the light should turn off.
You need to change the oil! And after that to turn off the light . It will cost you about $30-40 depending on oil brand and the filter. If you did change oil and it still on, you have to reset the computer by using an error code error which can erase codes or by disconnecting the battery for about 5-10 minutes.
The only way to get the oil change light off of a 2007 Saturn sky is to change the oil in the car before the engine blows up.