Turn the distributer to the right very slightly
can someone tell me how to adjust timing on a geo metro 1996
Probably computer controlled and not adjustable
electronic ignition on the 93, no controll. just set your timing.
need to know how to set the timing marks on a 1993 Geo Metro?
The timing marks on a 1993 Geo Metro are located on the on the camshaft and crankshaft sprockets. They must be aligned together to ensure proper initial timing.
A 1995 Geo Metro ignition coil is tested by measuring the resistance across the coil. If it exceeds the manufacturer's recommendation, it must be replaced.
-6 degrees BTDC
Firewall Drivers Side
They sure are. Metro rear windows were the same from 1989 - 1994 and 1995 - 2000. Hope this helps.
Answer: The ignition timing on a 1990 Geo Storm is 10 degrees BTDC. This applies to both the SOHC and DOHC 1.6L engines.
Can you swap a 93 Geo metro manual transmition with a 95 Geo Metro
my book says 5 degrees BTDC
The related link shows in detail
ignition timing or cam timing. see my profile for link. answers both.
in the fuse panel on left side of engine bay
Take off the screws that hold it on?
That depends on whether you're lining up 2 timing belt pulleys to the timing marks or lining up water pump/alternator/crankcase pulleys Mr Geo Metro email@example.com
yes and the transmission too is recomended..... These trans are not so reliable and if there's lower miles on the 2000 you should swap out the entire rig
start with timing, after this, you should be able to test your throttle position sensor with and ohms metter to determine if its good or not.
General Motors A Geo Metro is a Cheverolet geo and Chevy metro are both made by suzuki in Canada
# 1 is closest to the timing belt and furtherest from the transmission.