Auto Parts and Repairs
Timing and Firing Orders
Plymouth Voyager
Timing Belts and Chains

How do you set the timing in a 1993 Plymouth Voyager van?

272829

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 19:28:27
2015-07-15 19:28:27

It is computer controled and not adjustable.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


If you are changing the timing belt you need to get a shop manual on your car from a parts store. It will show you how and have pictures.

water pump on this 3.0 is driven with the timing belt. it is internal water pump you will have to set your timing before you start replace your timing belt if it is worn out.

Which engine?? Buy a service manual from your local parts store and line up the marks.

Timing is set by the PCM and is not adjustable.

How do you disconnect the Data Port when setting the timing on a 1993 Toyota Corolla?

Timing is set by the PCM and is not adjustable.

To set the timing you unplug the temp. sensor in the thermostat housing and set the timing to 12 degrees before T.C. with the automatic trans.

Ignition timing is electronically controlled.

This information can be found in the owner's manual. This information can be found in the owner's manual.

The airbag computer has detected a malfunction and set a code.

The distributor is set to 0 deg with the scan tool. It is not possible to set it with a timing light.

You will do better to purchase a haynes manual, specific for your car. That will ensure that you get your timing marks right. To set the timing you will need to disconnect the coolant temperature sensor to get the system to respond. Once set you will need to plug it back in.

where is the spout connectoe on a 1993 f150 5.0?

you cant set the timing its all done within the engine control unit ecu and is done electronically

you will need a c-clamp and screwdriver and ratchett set.

To set the timing belt on a 1993 Tercel the cam shaft markets must be lined up top dead center. There are arrows engraved on the engine labeling where exactly to install the belt. Failure to correctly set the timing belt can lead to catastrophic engine failure.

The distributor is synched to zero with a scan tool, it can not be done with a timing light.

need to know how to set the timing marks on a 1993 Geo Metro?

the cam gear mark is set at 6 o' clock and the crank gear mark is set at 12 o'clock.

unhook - side of the battery and let set 5 mins and reconnect and the light will go out.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.