Turn the ignion on, turn radio off. Press the "Set" button. Use the "seek" and "scan" buttons to set the time.
How do you set distubitor timing on pontiac 455?
What is the set timing of a 1992 Mitsubishi Expo?
show me the timing marks 2004 pontiac 2.2 dohc
You don't. It has no distributor. The only thing to make sure of is that the timing chain is installed correctly....(if you've removed it) and that the plug wires are routed correctly. If it's running poorly you'll have to look at other reasons besides the timing.
To set timing correctly on a 1992 Honda Civic the distributor must be installed at the right angle. Install the distributor at the correct degrees to ensure the timing is set properly.
how do i set my timeing on a 1992 cadillac v8 4.9 liter
To fix the Pontiac Sunfire if it jumped time, the timing belt has to be replaced. Then the car has to have the timing set again after the belt is replaced.
If you are just trying to set the stations in, go to the station you want programmed. Then press and hold the number you want it preset to.
Probably computer controlled and not adjustable
you cant, its factory pre set. non adjustable
disconnect the tan wire connector on the passenger side wiring harness , that puts it in bypass mode, unlock dist. bolt and adjust timing. when set reconnect wiring connector.
how i can set 1997 Mitsubishi diamante timing beltAnswerhow i can set 1997 Mitsubishi diamante timing belt
The computer should set the timing automatically by the sensors. If you change it, it must be done with a handheld computer.
Both engines that are available in the sunfire are electrically controlled timing. You do not need to do anything to sett the timing, the ECM does all the work.
can u give me a diagram on the timing marks for my 95 hyundi elantra
please send diagram of timing chain What engine type is your Grand Am? 2.4, 3.1 or 3.4?
A "timing set" includes all the parts needed (new timing chain, tensioners, sprockets, etc.) A timing set for this car costs $132 and up.
The timing is electronic and is not adjustable.
The timing should be set at 0 degrees.
When it is disconnected it puts the electronic timing control module in limp mode,and then you can set the timing with a timing light.
There are markings on the camshaft sprocket and the crankshaft sprocket. When one is lined up with a notch in the rear timing belt cover, the other should be lined up with the 10 degree mark on the front timing belt cover. Note that you will probably have to remove the front right wheel and splash guard to see one set of markings and the front timing belt cover to see the other.
my book says 5 degrees BTDC
Ask questions, submit answers, leave comments
Earn points for using the site
Customize your profile
Already have an account? Log in