On A 1994 probe se it can be manually adjusted by lining up the timing marks on the timing belt.
AnswerBuy a book.The crank shaft has a mark for timing. You have to pull the pulley off first and line it up. Then the cam shaft gears do have a mark. Line I with E. My cam shafts each have both marks. Its complex if you take the gears off the cam shaft without paying attention. If that happens then you have a lot off homework to do---studying the positions of the cams and firing order, ect. could be a mess---good thinking, learning lesson for a novice---good luck. Finally the distributor timing needs to be set. I discovered that the rotor that spins around inside the cap can go on 3 different ways---pay attention before replacing and don't be afraid to mark positions and directions of these three main vital componites that make the engine run: Crank, cams, and distributor. Little more complex than nuts and bolts.where are timing marks on 89 ford probe 4 cylinder I have the bottom not the top
To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.
They are on the camshaft and crankshaft sprockets
how do you set or check the timing on a 99 ford expedition?
where to set timing for a 1988 ford ranger 2.2l
how do you set the timing belt on a 1997 ford contour 2.0 4cy
Im replacing the timing belt on a 1995 Ford Escort 1.9L. How do I Set the timing on it?
"How to set timing on 1991 ford escort lx 1.9?"
how do I set the timing on a ford f700 truck 370-4
how to set timing on ford 1987 f-100 302 without timing light
How to set timing in step by step
yes.