0
The valve timing on the Nissan LD28 is the same as the L28 except on the end plate that holds the camshaft there are two dashes stamped in the longer of the two is were you should line up the the window marked 1 .You must insure that #1 piston is at T D C .An easy way to find T D C is to remove the rubber plug on the back plate over the starter and turn the crank until you see the dash on the flex plate line up with the notch in the circle the rubber plug was pulled from .
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you set your Nissan 1400 carb timing?
how to set the valve timming on a nissan 1400
How do you set the LD28 diesel timing?
See http://wiki.answers.com/Q/What_is_the_belt_timing_for_LD28
How do you set the timing on a 1994 Nissan Quest?
Disconnect IAC valve- ACC valve sub harness connector.
How do you set the timing after replacing the distributor on a 99 Nissan Quest?
how to set timing on 99 nissan quest 3.3
How do you set injector pump timing on Nissan cabstar?
how do you set injector pump timing for a Nissan cab star? provide a diagram.
How do you set the Timing marks for QG 15 Nissan engine?
http://www.justanswer.com/questions/2d6n5-set-timing-marks-Nissan-qg-9
How do you set the Timing marks for QG-15 Nissan engine?
http://www.justanswer.com/questions/2d6n5-set-timing-marks-nissan-qg-9
How do you set timing on a 1988 DOHC 16v scirocco?
Ignition timing or valve timing?
Can the timing be set on a 1996 Nissan 4x4 with a 4 cylinder engine or is it electronic?
Yes the timing can be set.
How do set the timing for 1999 Nissan Sentra 1.6 engine?
where are the timing marks on the 1999 nissan sentra 1.6 ex
Where and what are the timing marks on a Nissan 240sx?
Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft. Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft.
How to adjust timing on pular srv n15?
how to set timing on nissan pulsar srv
