real easy. screw in a cross bar, connect three wires and screw the motion detector on to the cross bar. Make sure power is off!
If you lost the manual, here's a scanned copy: http://pages.sbcglobal.net/rickblack/Public/
motion pictures and radios
If you are replacing a 02 sensor with a new one I would cut off the wires at the sensor and slip a 7/8" box wrench over the sensor and remove it with a counterclockwise motion.
Not necessarily.
no
If you are replacing it with a new one I would unplug the sensor from the harness and then cut the wires off at the sensor. This will let you slip a 7/8" box wrench over the sensor and using a counterclockwise motion remove it.
They use models to test their designs of new technologies.
If you are replacing it with a new one, unplug the sensor from the harness, cut the wires off at the sensor, slip a 7/8" box wrench over the sensor and with a counterclockwise motion remove the sensor from the exhaust pipe. Install the new one using a 7/8" open end wrench and tighten as you would a spark plug, reconnect the wires to the harness.
Macau New Technologies Incubator Centre was created in 2001.
because old tech is the base of new tech..
Not much info there but in most cases if you are going to replace it with a new one I would unplug the wire harness then cut off the wires at the sensor then you can slip a 7/8" box wrench onto the sensor and break it loose with a counterclockwise motion and remove it.
who was the person who brought new spinning technologies from Britain to the united states
pros and cons for the heavy investments in the new technologies