Disengage blades, push down and/or lock it and turn the key. If nothing happens, the most common parts for failure are the key switch and the solenoid.
9years
I believe it is 1.9 qts
Where is the low idle fuel mixture adjustment on a 2007 LT 1046 cub cadet riding mower model # 13AP11CH710
I have a 2007 cub cadet LT 1046 riding mower. I wish to adjust the low idle fuel mixture, but cant find the adjustment screw. Could you tell me where, and would I have to take off any other components off to get to it? the mower has a Kohler Courage 23 HP Model SV 720S engine. Thanks- Butch.
Disconnect the solenoid wire, turn the bowl counter clockwise. No tools are needed.
goto http://www.partsandservice.com/HTML/Murray/lt/lt40808x8d.HTML
Pull starter apart. Clean commutater and the grooves in the commutater. Make sure the brushes are good and reassemble. Should work well.
Less is 0.15 lt 1 lt = 1,000 ml So 0.15 lt = 150 ml and 150 is smaller than 300
The idler pulley is located just in front of and to the left of the right-side mower pulley. It's mounted on a bracket which has a long spring attached from it to the front of the mower deck. You can see a good diagram of this at www.partsandservice.com/html/Murray/lt/lt42910x92a.html and click on "mower housing". The belt is Murray part # 37X75 which translates to 1/2" wide by 91.25" around. Any larger mower shop would have this or an aftermarket equivilant.
I have a JD LT 155 C. I have replaced the solenoid and the mower still want start. There is 12 volts between the battery and the solenoid. When I test the voltage between the solenoid and the starter, the reading is 5 to 6 volts. Why is there a drop in the voltage to the starter?
The deck must be slipped beneath the machine from the left, the lift lever locked down and the rear hangers and front hanger plate attached. The belt will take take a 90 degree twist with the front part to the left side.
lt looks like a thick pherighraph