answersLogoWhite

0


Best Answer

Don't know if you're doing something wrong - you haven't said what you're doing or what model British Seagull engine that you have.
Be sure to try starting the engine in a tub of water.
Be sure your fuel mixture is correct (see any of the British Seagull sites for correct mixture for your model).
Be sure you have the right amount and right weight oil in the gear box.
Be sure the spark plug is the right one and is properly gapped.
After all that, either in a tub/tank of water or on the boat (and my British Seagull is a FeatherWeight 40, and therefore doesn't have a clutch or neutral - so the boat must be facing the direction I want to go...the minute the engine starts):
1) Open the brass part of the gas cap 1/2 turn (the bottom part of the gas cap remains firmly in place);
2) Reach around the back of the engine and pull out the brass fuel flow button (I think it says "Pull out" or something equally instructive);
3) Close the throttle (that thin slice of metal near what appears to be a muffler);
4) Find the little round button that pushes up and down and push it until gas drips from the fuel line (unfortunately, it drips into the water - not environmentally conscious);
5) Put the speed controller button (usually controlled by your thumb) all the way open
6) Wrap the starter cord around the pulley in the direction the arrows point;
7) Take your hand off the pulley - maybe rest it on the gas tank. When the engine starts, the pulley rotates rapidly and can cut or burn your hand if it is in the wrong place.
8) Pull the starter cord. Pull it again if it doesn't start.
9) If it continues not to start, try opening the throttle (the thin piece of metal near the muffler); and or let the engine rest before trying again. It may be flooded.
10) If it still doesn't start, take it to someone to be tuned up. There's a lot of old guys around who know about this engine and may be able to help.
11) If it still doesn't start - hey, its a British Seagull engine and has vowed to drive you crazy.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you start a seagull engine that wont start Am i doing somthing wrong?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When doing a compression test on a gas engine do you start the engine?

No, The compression test is done as the starter cranks the engine


What is somthing you eat that start with l?

linguine


What is the price range for Seagull guitars?

Interestingly Seagull guitars are made from start to finish in Canada. The most expensive Seagull guitar can set a person back over a thousand dollars, the cheapest about three hundred and fifty.


How would a peasant start his day?

by stealing somthing


Your seagull 4 hp 2 stroke outboard motor will not start just keeps backfiring through the carby any suggestion78s the carby has just been serviced engine no LLS231?

It sounds as if your engine may be out of time, I would check for a sheared flywheel key.


Will a car start even if head gasket blown?

Yes, it will start. But know that every minute you run the engine you are doing damage.


I beat the level the storm in halo 3 but it wont give you your achievement for it are you doing somthing wrong?

to get the achievement you have to play it on normall dificulty or above and start from the begining of the mission not the check points


What is a prefix word to do somthing that you should not do?

It should start with (mis) :)


Why wont engine start Holden Astra warning light flashing?

my car doing the same thing


Can you change the timing belt and water pump yourself on a 2003 Honda odyssey?

Not unless you know what you are doing. This is an interference engine. Do this incorrectly, start the engine, and you will have internal engine damage.


Why can z never be larger than a?

the finish is the start of somthing new.


Why Ford escape 2004 engine would not start?

it depends on the circumstances, and what it is doing such as the noises it it making. Go and by a book.