0
You take a bearing by pointing your compass at the target (or direction you want to go) and reading the number on the compass. There are 360 degrees in a circle, with East being at 90 degrees, South-East being 135 degrees, South being 180, West 270, North 360 (or zero) and etc. etc.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Install Ford Festiva wheel bearing?
Installing wheel bearing in a Ford Festiva is simple but will take some time. All you have to do is take the hub off, take out the tie rod and then take out the wheel bearing from the hub.
How do you take the throw out bearing out of a 1990 Chevy silverado 350?
you have to remove transmission to take out and replace throwout bearing
How do you take a back bearing off a 1979 fl250 Honda oddessy?
which one, the carrier bearing or the gearbox bearing?
Can you grease the front bearing on a 2000 alero?
You can if you take the bearing completely apart. There is no nipple
How to replace Wheel Bearing on a 2002 Celica?
If it is the front bearing: Take it to a mechanic. The bearing in pressed into the spindle. A press is required to remove the old bearing and install the new one.
How do you replace front wheel bearing on ford maverick?
Take wheel off, put bearing in
A auger bearing for a 1977 sears 5 HP snowblower?
pull or press the bearing out and take to a local bearing/machine shop to measure
What is fore bearing in civil engineering?
In survey when take level of spot in forward direction is forward bearing opposite to back bearing which if back direction
How you can take main bearing clearance marine engine?
the clearance is measured at the top of the bearing with the help of a feeler gauge
How do you install throw out bearing Mazda rx7 1985?
the throw out bearing is located in between the engine and transmission so you must remove the transmission and it will be on a fork holding the the throw out bearing on the transmission but remember that when you take out a tranny you must take out the the oil from it
How do you change wheel bearing for saxo vtr 51?
take it to a garage, or remove the whole suspension leg and remove the bearing yoursef but you will need a hydraulic press That applies to the front bearings. The rear wheel bearing are push-bearings and are easy enough for anybody to do themselves. Take the wheel off. Take off the brakes. Undo the bolts. Pull old bearing out. Push new bearing in. Put in bolts. Reconnect brakes. Put the wheel back on.
What is pedestal bearing?
its an item u can have your Pokemon take a pic with
