No u anit got take the balljoints out.
right top of the radior hose first take off the bolts (must be 2) take out the cap, then you will see a thermostat inside then just replace it, that's it! how easy
brake lights won't go off 1995 acura intergra
When changing the lights on a 1995 Acura Integra remove the dash on the center console and pull it off. Remove all the accessories and reach the old bulbs. Replace the bulbs.
take off back seat ash tray and its right there
how do you take off the shifter on a 1995 6speed corvette
Check your firing order 1342
how do you change the sterter on a acura integra the starter is on the passenger side. it is hard to get to depending if it auto or 5spd. there is more cluster in the autos. i have a 5spd. i went from under the car to get to it. just got to take off the bolts. take it out put new one in. make sure it is lined up straight. if not you will here it grind a lil when you go to start the car.
1/2 drive Ratchet
You can obtain 1995 Acura diagrams at most Acura dealerships. You can find the diagrams at most auto-parts stores. Many auto-parts stores will print the diagrams off for free.
Don't take my advice because I don 't know, but take off the old one and put on the new one.
pull handle out theres a screw there take it out pull the cover off pop the arms off that hold handle lock and handle
how do you get the alternator out of a 1995 safari van.I took off the front bolts but still not coming out must i take off the "doghouse"to get access how do you get the alternator out of a 1995 safari van.I took off the front bolts but still not coming out must i take off the "doghouse"to get access
You can install any Honda b series hydraulic transmission to your car, like the integra gsr transmission, or the integra type r transmission
Take the pump out of the tank, then be done and happy.
If it's a halfshaft that's broken in half I would not drive it. It might flop around and tear stuff up. if It's sheared off rotationally (like the splines are worn out) then you could get by with just not putting it in 4wd. That is, unless it's sheared off in the hub, then you get metal bits in the hub/wheel bearing. That could lead to major safety issues. If anything other than a halfshaft is broken then don't drive it. You might have a bad day.
just turn it off
to take off the engine light take out the positive wire on the battery then hold down the brakes for 30 sec. if the lights still on then sumthing is wrong with the motor
i have a 94 integra so I'm not sure if its the same but if you look at the rotor after taking the cap off you will see there is a space behind the rotor a little opening if you look while someone tries to crank the car you will see a screw when it is in the right spot be carful when you go to take it out if you strip it its going to be hell to get off once you have the srew out just pull it off
you may have air in the brake line. bleed all the brakes. if the light still comes on intermittently go next to bleeding the line at the master cylinder.
Should be "peel off" after removing brake caliper, unless it is rusted to center hub. Then try WD-40 or similar product to remove rust or corrosion.
drop cross bar under car and the headers and maybe one more hanger then u can take oil pan off
The factory tape deck on a 1996 Acura Integra can be taken off by removing the center console. Once the console is off remove the remaining mounting screws on the radio and pull it out.
Take the filler neck off and the thermostat will be right there
You do not as it is programmed in the computor.