You have to look carefully at the door panel. It would be like taking any other panel off a door. You need to look for screws, some my be hidden. If you can't find any screws the panel is probably just held on by clips. Take a screwdriver or something flat and rigid and carefully insert it between the door and door panel and pry outward. You might break some of the clips (it's almost impossibly not to), but any auto parts store carries them for cheap. Once you have the door panel off disconnect any wires and there you go. Access to you speakers. Good luck.
What is the pAyload for a 1991chevy blazer four dood
5 1/4 for the back doors and 6 1/2 for the front doors. I am not sure about the dash board speakers.
my Chevy blazer 2001 4 door has 6 speakers
how to replace a heater core in a 1997 Chevy blazer
There should be 4 door speakers in a blazer - all of them are 6 1/2" speakers. I do believe you need to pull off the door panels to replace the speakers, I have not done that to my truck yet.. Hope that helps you.
how do you replace seatbelt retractor on a 2000 chevy blazer
where is the blower motor on a 2001 chevy blazer
the speakers in the dash are 4x6s, the speakers in the doors are 6.75in. and the back speakers are 6x9's
how do you replace dome light in s10 chey blazer?
The side door speakers are usually six inch, at least they are in my 95 blazer. If you buy one of those repair books based on a complete rebuild, it gives detailed instructions on how to take off door panels, replace speakers, etc.
How do you replace fuel injectors on 2003 Chevy blazer?Read more: How_do_you_replace_fuel_injectors_on_2003_Chevy_blazer
i just recently put new door speakers in a 2000 Chevy blazer. They are 6 and 1/2 in all four doors.
You get a pro to do it.duuuhhhh
That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?
pull the gas tank out and replace it
4x6 in the dash and 6x9 in the rear
The 1988 Chevrolet Blazer front speakers measure three inches by four inches. The rear speakers measure four inches by five inches.
Remove the speaker covers. Each speaker cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
on the front axel
5 1/4" I have the same year blazer and i just replaced all my speakers. At least it's 5 1/4" for the door speakers and i can't tell but there's places in the dash board for 4x6" speakers.
We replaced the temperature gauge in my 1991 Chevy blazer what is the normal operating temp?