answersLogoWhite

0


Best Answer
some wut of an Answeryou take off the center bolt then you rent/buy a harmonic dampener puller/installer and screw the three 3/8 bolts into the harmonic balancers body and pull it off by turning the center stud wich seperates the balancer from the crankshaft. and follow the same steps for re-installation now you are pressing the new balancer on the crank make sure the keyway on the shaft and the pulley are aligned or its gonna cost you a new crankshaft and if you replace the crankshaft might as well re-build the engine.

It's obvious that before any thing you have to remove your belt/fanclutch and fan/ fan shrowd or you will not have any room to work.

94 grand Cherokee Laredo 4.0

berto

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you take of a harmonic balancer on 94 jeep wrangler 6cyl?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Manufacturer torque requirements for harmonic balancer on jeep 4.0L?

80 Ft-lbs


What 5 speed is in a 1997 jeep wrangler sport?

4cyl AX5 6cyl AX15


What is the proper way to remove harmonic balancer on 92 jeep larado 4.0 motor?

harmonic balancer has threaded holes for attaching the proper puller.remove big nut from shaft then use whell puller


What transmission is in a 1995 Jeep Wrangler?

AX-15 in 6cyl AX-5 in 4 cyl


Will a 1995 jeep Cherokee 6cyl starter go into a 1995 jeep wrangler with a 4-cylinder?

It shouldn't, the engine blocks are different.


Is a 1993 Jeep Wrangler 4.0 6cyl engine interchangable with a 1989 Jeep Wrangler 6cyl frame with out cutting and welding and changing wiring harness?

Yes, that should work just fine, they are both YJ's and 6 cylinders so all should match.


How do you change a harmonic balancer on a 1999 Jeep Cherokee 4.0 L?

Remove the belt. Remove the bolt that attaches the harmonic balancer. Rent or purchase a harmonic balancer puller. Follow the Instructions with the puller and remove the old balancer. Install the new balancer making sure to line up the keyway, a little oil helps. Put the retaining bolt back in and tighten to manufacture specs.


What is the size of the harmonic balancer bolt on a 91 jeep Cherokee 4.0 engine?

1/2-20x1 1/2


1991 jeep wrangler Sahara 6cyl where does the oxygen sensor plug into?

the oxygen senor plugs into the manifold on the left side of the engine if faceing the jeep from the front.


How does the harmonic balancer tighten on a 1989 jeep Cherokee Laredo without turning the crank over?

Easiest way is with an air impact. There are strap clamps available that would go around the harmonic balancer that would hold it while the bolt was tightened.


Jeep Cherokee harmonic balancer?

A mechanic will be able to help you with this. They have the right tools to make sure that the whole vehicle is properly balanced.


1989 jeep Is the harmonic balancer bolt righthand or lefthand thread?

Normal right hand thread. Counter clock wise to loosen.