Window cranks are easy to remove. Go to the local auto parts store, and ask for a window crank removal too. Slip it in behind the crank until it comes free.
lock located between the panel and handle. take small screwdriver to pry gap between back of handle and panel. then take another screwdriver push the silver lock ring off the shaft . then handle should slide off
There is a simple tool you can purchase for very little money that will release the "C" clip that is behind the handle. This tool is available at your local auto parts store.
How do I take off the handle to put a new one on a chevy colorado 2005
You have to pry the clip out of the slot behind the handle
same as you do on any other Chevy . There is a special tool made for it but i make mine out of an old regular,flat head, screwdriver by bending the tip 90 degrees with a 1/16 lip. Squeeze it down behind the handle until you find the clip grab it and pull upward and it will come out and you can take your handle off !
Take the inside door panel off and you may find the forward window channel lower bolt loose or missing or the bracket cracked in half.
I'm assuming you are talking about the interior handle possibly the manual window handle. If so, you need to push on the area surrounding the handle to expose a small clip. use a standard screw driver to push the horsehoe looking clip to remove the manual window handle. To remove the arm rest there are two hex screws on either side..they are somewhat hard to find. You can then take steps to remove the inner door moulding.
I suspect the rod that opens the door has come loose or broken off the door handle and is keeping the window from coming down. Take the inside door panel off and check. If needed just replace the door handle.
There is a special tool that is designed for this but, if you have patience, you can get away with a couple of screw drivers. There is a wire clip that needs to be removed at the base of the crank. It's a little hard to get to but, if you push the door panel in a little, you should be able to get to it. Disconnect the wire clip and the crank should pull off.
To take the window handle off of the 2005 Kia Spectra, you will first need to remove the interior door panel. This panel pries off of the vehicle using a flat screwdriver or a prying tool. Then, access the door handle by removing its cover and then remove the screw at the center of the handle.
how to take the door panel off of a 1997 mercury marquis
it is a 97 saturn There is a very small clip holding the window handle on. A special tool is required for removal.