How do you take off the motor mount on Toyota corolla 2004?

Answer 1

there are tree engine mounts im going to take a guess and say it is tha one closer to the lower part of radiator you will need a floor jack a square piece of wood to protect your aluminum oil pan im trying to remember the size of the bolts i think the top youll need a 17 mm deep socket a long extension 14 18 inches long a wratchet pref 1/2 drive remove the top bolt of motor mount wd40 make job a bit easier. nut is expost to water and heat all the tim after nut is off get floor jack with the wood between the jack and a flat part of pan do not let metal pad from jack touch oil pan just the wood jack up very slowly the upper bracket mounted will start to lift off the mount. now not knowing what engine you have i will tell you both types of mounting for 2 different types. hold you new mount in hand does it have a stud(bolt) on top and bottom if oit does slide under car a lokk where motor mount is located on bottom frame when you find this spot there will be a oval plastic cap you need to pop out of frame rail very easy and thin plastic now look up in the hole and you will see the bottom stud and nut remove nut usually the same size as top now look down a mount from top and jack motor just high enough to snake the mount out pay attention the way the mount comes becuse ther is a top and bottom. pay attention to alignment pins that they seat correctly. remember alum cracks very easy when pushed the wrong way. take new mount instal stud in bottom then lower engine slowly but not all the wat give reme to put pin and stud on upper mount you might have to wiiggle engine by hand to get back in once its in lower jack mount upper and lower nuts fairly tight is ok put plastic access cover back in this keep water fom sitting a rotting frame rail the othe type of mount uses 2 14mm bolt from the top i hope this helps you email is ok g