answersLogoWhite

0

How do you take off the valve cover on a 1987 Camry?

Updated: 8/17/2019
User Avatar

Wiki User

14y ago

Best Answer

pull the spark plug wires out from the valve cover and unscrew the four nuts it will come right off.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you take off the valve cover on a 1987 Camry?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much engine oil does a 1987 Toyota Camry take?

A 1987 Toyota Camry will take 5 quarts of oil. The type of oil the Camry uses is 10 W 30.


Is it hard to replace the valve cover gaskets on a 1998 Toyota Camry?

On 4 cylinder it takes about 20-30 minutes. For V-6 it might take couple hours.


How do you put oil into a 1987 Ford Ranger?

you take the cap off the valve cover on the passenger side of truck or the oil breather cap on driver side to add oil


How do you install the valve cover gasket on a 1988 Cadillac DeVille?

take off valve cover throw away old gasket replace old gasket with new put valve cover back on pwn


Should you need to replace the valve gasket when you replace the timing belt on a 2000 Hyundai Elantra?

you should only change the gasket if you have to take the valve cover off....... you should only change the gasket if you have to take the valve cover off.......


Where are the head bolts located prelude?

Your head bolts are located under your valve cover. Take your valve cover off and you will see them. Hope this info. helped.


How do you remove the valve cover gasket?

Take the valve cover off and scrap the gasket off with a razor. Be carful not to put any gouges in the on either side.


Does the 2002 Chevrolet Silverado 5.3L engine have a PCV valve?

look om the passengers back side of the valve cover. You need to take off the vortec cover.


What to do when a vehicle is leaking from the valve cover?

Change the Valve Cover gasket. Its very simple, just take your time. pull all the bolts around the valve cover, use a mallet to lightly tap until the cover comes off. there will be a seal inside the edge of the cover, scrape/pull it out. replace with a new gasket and heat resistant sealant. Bolt down the valve cover and you're done.


How hard is it to replace the PCV Valve on 1995 4 cly Camry?

It's easy, if you know what you are doing it should take you about 15 min including replacement of PCV valve grommet.


How do you take out the old 6x9 speakers of a 1995 Camry?

In the newer car the speakers are mouted from the top. Take off the cover and see if you can get to the screws from there.


Where are the sparkplugs on a 1998 maxima?

down in the middle of the valve cover. just follow the spark plug wires. if there is a plastic cover over the motor take it off. there will be 3 in the front valve cover and 3 in the back