0
skill. you'll have to undo the sump plug and let a bit out. It can get a little messy.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you change the transmission fluid in 1991 kawasaki voyager?
On the voyager XII, the engine oil and the transmission oil are all the same. Draining the engine oil takes care of it all. On the voyager XII, the engine oil and the transmission oil are all the same. Draining the engine oil takes care of it all.
Where is the oil pan located on a 2005 ford escape?
On the bottom of the engine block. It has a drain plug in it for draining the oil.On the bottom of the engine block. It has a drain plug in it for draining the oil.
How much engine oil does a 1986 Honda nighthawk 450 take?
Just draining to change the oil = 2.6 quarts
Where is the engine drain plug in a 1993 Toyota Camry?
That really all depends on what you are draining, the oil drain plug is located directly under the engine.
How much oil is needed to refill after draining all of the Oil in a 14.5 hp engine?
Depends on the brand of engine and the exact model. Also depends if you change the filter. Read your owners manual.
Will changing the oil will help if there's too much oil poured into the engine?
Draining the excess will solve the problem.
How much oil will a 1986 Honda 350 fourtrax take?
"Honda service manual says...2.4 quarts when draining...and 3 when completely disassembling engine."!
How much oil do you need to put back into a cavalier after draining the oil out?
all of it
Why does oil drain very slowly on Chrysler Intrepid 2002?
Try draining the oil after the engine has warmed up first.
After draining engin oil it still shows overfull on dipstick Can oil be trapped or not draining?
you may have in correct dipstick in vehicle OR clean the dipstick and then re-check.... or if its an older 5.0 engine, there is 2 drain plugs...
1980 115 hp outboard motor mercury oil change how?
first of all what oil your are talking about , i hope not engine oil because there is non that is two stroke engine. lower unit has a draining bolt on the bottom and air or fill bolt on the top of the lower unit....
If a 3800 engine has milky oil what could be the problem?
i hate to let you know this but you have water in the oil pan which means that you may have a blown head gasket. the antifreeze is draining into the engine by draining into the cylinder or cylinders and dripping into the engine case. do not run the engine with this condition as it will seriously damage the engine. you may also have a crack in the water jacket inside the engine block which would allow antifreeze to drain into the engine case.
