The interior front door panel of a 4-door is attached to the door with two screws in the arm rest, three at the bottom of the panel, one at the edge nearest the door latch, and one in a separate plastic panel near the outside mirror. Remove the screws using a Phillips screw driver, then gently pull on the panel to remove it. After loosening the panel there is an electrical connector to unplug (with electric door locks) before the panel can be completely removed from the door. Removing rear door panels or the panels on 2-door Cavaliers should be similar.
front 4x6 back 6x9
in the fuse panel drivers side behind the door marked HORN
You can put a manual rollup window back on track, in your 1994 Chevy Cavalier, by removing the inside door panel. The window track is easily visible with the door panel removed.
luck
i think it is 40 psi but it can vary check the tire or the side of the door panel for it.
In a repair manual - I have Chilton's but Haye's will also do.
fuse panel is in the drivers door jam left side of dash
Remove the screws in the door panel.
Take door panel off then it's as easy as 1-2-3
There should be screws located on the bottom and sides of the panel which u tighten in place. AND, replace those white push-pins
Open the Driver's door and look at the side of the dash. Remove the side panel panel.
I have a 97 Cavalier,,,and one key does the door , ignition and trunk.