Depends on what symptoms you're getting. Is it running with vibration? Or is it so badly scored that the clutch won't work? It's most unlikely that you'll need to replace a flywheel. They don't really go wrong.
Need to replace the ingnition module in the Distributor.
mounts for 454,poss flywheel,computer for 454
The rotors are out of round, WARPED. Need to have them turned and replace pads too.
No, there is no need to replace the flywheel but it is a good idea to have the flywheel surface machined.
Big job. To replace a flywheel, you need to remove the drive shaft,and the gearbox. iIf a manual transmission,you will also need to remove the clutch and pressure plate.If an automatic, you will need to remove the torque converter. With all this removed, you then remove the flywheel and replace with new one. then reinstall clutch,etc gear box and driveshaft.It is a good idea at this time ,if a manual transmission,to replace the clutch,while you have it apart. "NOTE" make sure when you replace flywheel that the correct number of teeth on flywheel will match number of teeth on starter motor.To do this mark a tooth on the flywheel and count the teeth.Alos count the teeth on the starter motor.installing wrong one will chew up the teeth on new flywheel and starter and then you will have to start all over.
Yes, it's the same pump. If you need to replace it, be sure to get either a Bosch or Delphi unit.
Where is front expansion valve for chevy suburban 1997
need a picture
My first stop would be the dealership. If you do not want to do that you could go to chevy.com to check out the Chevy Suburban. They would have all the info you need to make your decision.
Sounds like solenoid is not releasing or ignition switch is not moving from start to run position. If solenoid is located on top of starter remove clean plunger and replace If solenoid is on firewall replace If the starter is not fully engaging the flywheel, you'll need to either replace the starter or the Bendix/solenoid assembly. If the flywheel has been damaged, you'll need to replace that as well.
Need to know the engine size.
I just replaced the front heater motor in my 99 Suburban, it worked great, now the heater/ac absolutely does nothing. Could the switch be bad, the motor, I am stumped and need help. Thanks Jim.