0
I have 2003 Kia Rio 4 cyl. i have change already the direct coil from the spark plug,change the spark plug,i have change also the fuel pump already and fuel filter too.my car everytime i start the engine run in a few in a minute and i could'NT accelerate the engine.after i start again and icould'NT start anymore i was especting it could be the crank sensor.is it possible the crank sensor give me advise.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you test a crankshaft position sensor on a 1996 jimmy blazer?
To test a crankshaft position sensor on a 1996 Jimmy Blazer, use a CKP sensor to test for voltage output. Compare the results to manufacturer specifications.
How do you test a Crankshaft position sensor on 2.2 l SFI cavalier?
how to test crank sensor
Can a crankshaft sensor cause a failure to pass smog test?
Probably not as the emissions test (Smog test) is carried out by inserting a sensor into the exhaust pipe.
How do you know when a crankshaft position sensor is going bad on a Kia Sportage?
ohm test it.
Can you test a crankshaft sensor for output how?
purchase an actron sensor tester for about $40 and follow the directions
How do you check if you have a faulty crankshaft sensor on a 106 independence?
Crankshaft sensors usually either work or they don't. However, using a vom meter, you can test the resistance of the sensor to see if its working.
Have a 94 mirage 1.5 no fire to the plugs changed the electronic ignition how do you check the crankshaft sensor and where is it located?
The crankshaft sensor in your 1990 former Roche is located on the front of the engine. The best way to test your crankshaft sensor is to hook the engine to a Dyno tester.
Can you test crankshaft sensor?
Sure can...hook it up to a diagnostic and it should bring up a code telling you that the sensor is out.
How can you tell a bad crank sensor?
A computer diagnostic test will generally tell you if you have a faulty crankshaft position sensor.
Where is crankshaft sensor on a 1995 Oldsmobile 3800 series II engine?
It should be behind the crankshaft pulley. You'll need to remove the right front wheel and the weathershields to get to it. If you only need to test the wiring, don't remove the pulley. == == == ==
How do you test a Crankshaft Sensor in a 1986 Nissan 300ZX?
Using a scanner with a scope, you can view the output wave of the sensor as you crank the engine.
Where is crankshaft?
Where does a crankshaft sit
