0
Look by the thermostat housing you will see a single wire with a "L" plug.
unplug the wire which is plugged in to the water sensor for the temp gauge.
Ground the wire to the engine block, turn the ignition key to on but do not start engine
look at the temp gauge it should read all the way to the right (in the red).
If you see this then the gauge is working and the sending unit is bad. If the gauge does not respond check the instrument panel fuse, if the fuse is good the gauge is bad..
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is the body temperature in celsius of dogs?
The body temp is 38-38.2 Celsius
What weight oil do you use in your 1989 Ford Taurus?
5w-30 outdoor temp. from & below 0 F (-18 C) to 100 F (38 C) 10w-30 outdoor temp. from 0 F (-18 C) to 100 F (38 C) & above temp.
On a 38 question test and 28 were correct what is the percent you got correct?
28/38 * 100% = 73.68% You got about 74% on the test.
Dogs normal body temp?
Higher than humans, about 38 degrees Celsius, or 100.4 F (Fahrenheit).
What is the value of a model 38 Winchester 16 gauge?
It can worth $600 to $750 depending on how good it is.
How much would 38 out of 50 get you on a reading test?
A 38 out of 50 is a 76%. This is calculated by dividing 38 by 50 (38/50). You then multiply the result by 100, and the solution is your percentage out of 100.
What is the exact type of ammo for a particular firearm?
Question is too broad to answer. In general, use ammunition that is the same as the caliber or gauge marked on the firearm. If it is marked .38 Special, use only .38 Special- NOT .38 S&W, NOT .380. NOT .38 Super.
What are the release dates for Campbell Playhouse - 1952 The Test Case 2-38?
Campbell Playhouse - 1952 The Test Case 2-38 was released on: USA: 26 March 1954
What is the value of a Smith and Wesson 38 gauge serial number 07682?
No such weapon made by S&W
What is considered a high temp?
Well 37.5 is the "norm" so anything over 38 (especially in a child). If it ever hits 40 I'd get to the hospital. You can also have a temp if it drops under the norm too.
What are the various sizes of thickness gauges?
There are a number different gauges for different products. For steel sheets, the gauge ranges from 3 to 38. For aluminum, the gauge ranges from 6 zeroes to 40.
What is a 38 out of 60 on a test?
A low C nearly a D. You nearly missed half of the test.
