Remove the oil pressure sensor, connect a manual oil pressure gauge to the port & start engine.You should have 10 18 psi at idle.
hope it helps, Slackers Of Va.
Where is the oil pressure sending unit on a 1995 F150 truck with a 302 motor at
The Expedition should, and that's about it.
With a fuel pressure gauge connected to the fuel rail.
Check fuel filters
Bad main bearing, bad oil pump... both are possibilities.
4.9L Inline-6, 5.0 v8, 5.8L V8
kick it between the legs and hope it dont bite back.
what causes hesitation on ford f150 truck
My Mom had the same problem with her truck.. It is due to a recalled part that is on the brake master cylinder
Worn crankshaft bearings, oil pump, or a defective oil pressure sending unit. Have a oil pressure test done with a mechanical gauge, the electric gauge is not very accurate and is prone too failure.
located at the upper end of the brake pedal under dash area
on the right side of the truck, inside the door. underneath the glove compartment, there is a hole in the siding of the inside fo the truck, reach in and tahts where it is