0
both pieces of twine come out of the twine chute, then under the tensioner on the outside wall of the twine chunte, through the slack springs, down through the insulator, then one string goes to the near side needle, and the other goes through the far side insulator, then threw the far side needle. Once they come out of the needles, tie them off to the round tubing at the bottom of the bailer.
Hope that helps!
What else can I help you with?
How do you time Massey Ferguson Model 12 hay baler knotters?
How do adjust the knotters on #12 Massey Fergurson hay baler
Who made Massey Ferguson 1565 baler?
They were made by Vermeer.
How old is a 120 Massey Ferguson baler?
A 120 Massey Ferguson baler was manufactured in the early 1970s. Given that it is now 2023, this would make the baler approximately 50 to 53 years old, depending on the specific year of production.
Why does the old Massey Ferguson 450 round baler stop up so easily?
Because its a closed mouth baler
How do you time a no 3 Massey Ferguson square baler?
To time a No. 3 Massey Ferguson square baler, first ensure the machine is properly set up and connected to the tractor. Locate the timing marks on the baler's flywheel and the knotter mechanism. Rotate the flywheel until the timing marks align, then adjust the knotter's drive mechanism to ensure it engages at the correct point in the cycle. Finally, check the operation by running the baler and observing the knotting action to confirm proper timing.
How do you determine the year of a Massey Ferguson 124 baler?
To determine the year of a Massey Ferguson 124 baler, you can check the serial number, which is typically located on a plate affixed to the frame. The serial number can provide specific information about the production year when cross-referenced with Massey Ferguson's production records. Additionally, consulting the owner's manual or contacting a Massey Ferguson dealer can provide assistance in identifying the year based on the model's features and specifications.
What size bale does a Massey Ferguson 560 baler make?
5 foot X 6 foot
Will a Massey Ferguson 12 baler take plastic string?
I have a model 12 MF baler, and I use the plastic twine all the time with no problems. Don in Oregon
What year is your 124 Massey Ferguson baler serial number 2183?
from what I could locate I believe your model 124 was manufctured in 1980
How do you time a Massey Ferguson 126 wire tie baler?
To time a Massey Ferguson 126 wire tie baler, first ensure the baler is properly set up and connected to the tractor. Then, disengage the tractor's PTO and manually rotate the baler’s flywheel to access the timing marks on the crankshaft and connecting rod. Align these timing marks according to the manufacturer’s specifications, typically found in the operator’s manual. Finally, reassemble any removed components and test the baler to ensure it operates smoothly and efficiently.
How do you set the timing on a Massey Ferguson 12 baler?
To set the timing on a Massey Ferguson 12 baler, first ensure the baler is disconnected from the tractor and safely secured. Remove the access cover to expose the knotters and check the timing marks on the drive gears. Adjust the timing by loosening the bolts on the knotter drive to rotate the gears until the timing marks align. Re-tighten the bolts, double-check the alignment, and replace the access cover before testing the baler.
What length are the leading 3 fingers on a Massey Ferguson 503 hay baler?
The leading three fingers on a Massey Ferguson 503 hay baler typically measure around 20 inches in length. These fingers are designed to effectively gather and feed hay into the baler for optimal baling performance. It's important to consult the specific operator's manual for exact specifications, as measurements can vary slightly based on the model and year.
