you can't. the timing is controlled electronically by the computer and various sensors.
Where is the backup light switch on a 2002 buick century?
well it needs to be serviced...soon
with hand held computer (scanner)
A person needs to pay attention to their warning lights. If a service engine light is flashing, this means that there is a problem within the engine.
how do you reset check engine light in 2008 buick lucerne
With a timing light.
NO. A timing light will not work on that engine. You must have an obdII engine scanner to set the timing on that year.
if your check engine light is on it may be the idle control valve
The 2001 Buick Century brake light switch is located beneath the dashboard, on the drivers side. The brake light switch should be labeled as such.
Depends on which engine warning light you are referring to. If you are taking about the Check Engine light, then you must have the problem fixed that caused the light to come on. It is an emissions problem and you need to seek the help of a professional.
You CANNOT use a timing light on that engine. ( won't work ) It requires an OBDII engine scanner to set the timing. The timing is computer controlled.
It does not have one. You can not use a timing light on that year engine. The timing is computer controled. You MUST have an engine scanner to set the timing.
When the trac light is off, on a Buick Century, the traction control monitoring system is disengaged. It is recommended to have the trac system engaged on wet roads.
A timing mark is usually a white line on the timing belt to sync the firing of cylinders in an engine. You can see this line when the engine is turned off or with a timing light also a strobe light when the engine is running.
NO there is not. The timing on that engine is computer controlled and it REQUIRES an engine scanner to set the timing. A timing light will not work.
The timing on that year engine is computer controlled. It requires an engine scanner to set the timing. YOU CAN NOT USE A TIMING LIGHT.
The check engine light on a Buick Regal can be reset with a special diagnostic scanner. This can be performed at a car dealership or service garage.
Trouble code P0420 means:Catalyst system efficiency below threshold (bank 1)
I have the same problem, I don't know what to do.
You can set the base timing by ear, But to be able to get the check engine light to go out and to set the timing were it is supose to be requires a engine scanner. The computer controlls the timing on that year engine.
Timing light. The instructions are on the engine hood.
You will need a OBD2 scan tool to reset the light after repairing the problem that caused the fault code. If you do not repair the problem the light will just come back on.