0
How do you time a crankshaft position sensor on a 1999 Chevy Metro?
Wiki User
∙ 15y ago
you cant. the crank sprocket is keyed (it will only go on one way) and timing is controled through the PCM. hope this helps.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Installation of a crankshaft position sensor on your Chevy Metro?
it is located on the head
What should be done to stop a oil leak from a 99 Chevy Metro crankshaft position sensor?
the seal on the crank shaft needs replaced
Where is the Wells Camshaft Position Sensor on a Chevy Metro 2000?
I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.
Where do you find the crankshaft position sensor on a 98 Chevy Metro?
Hi there, You can find the Engine Crankshaft sensor for a 1998 Chevy Metro in the bottom front of the oilpan. Note, it goes thru the oilpan but, it's Not part of the oilpan or in the "oil chamber" itself. It's held in place with two (2) bolts. No oil will come out when you remove it. There is one (1) electrical connector on the sensor. Note, this can be easily mistaken for the oil pressure sensor. Note, they are prone to getting "dirty", so clean it off after removing. Good luck. John
Can you add a Crankshaft posistion sensor from a 1998 Geo metro on to a 1993?
no they didnt have them till 1996 with the obd2
Where is vacuum sensor located on a 1991 Chevy Metro 454 engine?
that must be some metro to have a big block
How do you install oxygen sensor for Chevy Metro?
you gotta take the old one out first
Where is the camshaft position sensor located on a 96 Geo Metro lsi 4cyl?
It is in the diistributor.
Does broken Timing belt bend valves on 1998 3 cyl. Chevy Metro?
no. all geo metro 1.0L motors are non-interference motors. however it would be a very good idea to make sure the timing belt tensioner spring and tensioner roller and timing gears were not damaged by the bad timing belt. also you will have to clean out any debris at the crank position sensor at the crankshaft when installing the new timing belt so the fragments will not interfere with the sensor picking up the timing signal off the motor
Where is the camshaft position sensor located in a 1992 Geo Metro Lsi 3 cyl?
inside of the distributor
Does a 2001 Chevy Metro have a speedometer cable?
NO cable. it has a vehicle speed sensor bolted into the transmission. Electronic controlled.
On 91 Geo Metro Convertible .Why do you have to run a hot wire to the coil to get it to run.I have replaced the ECU and that did not work?
Does it have an ignition control module? That may be the cause. Or possibly a MAP sensor or a Crank position sensor or Cam position sensor. Check those first.
