You have to buy a special module to install in car.
Repair the issue which is causing the light to turn on.
To inform other drivers of your intent to turn. Or when used in unison as a warning that the vehicle is in trouble or stopped or broken down on the side of a carriageway. Improved answer: To switch 'on' the signal light
There is an electircal switch that 'senses' when the emergency brake lever is applied and lights a warning light on the dashboard to keep you from driving in this condition. This switch may be faulty or out of adjustment, causing the warning light on the dashboard to turn on.
The air suspension warning light will be displayed on the dash if you have flipped the switch on the passenger side of the trunk to "off." Look opposite of where your fuel filler door's manual opener is and flip the switch to on (it is not labeled on, only a blank space on the top of the switch and "off" on the bottom). I believe the question is to turn off the warning light, and not where the breaker switch is. If the warning light for the suspension is on, that means that something is wrong with the system. Have it checked before you find the rear end of the car on the ground.
To inform other drivers of your intent to turn. Or when used in unison as a warning that the vehicle is in trouble or stopped or broken down on the side of a carriageway. Improved answer: To switch 'on' the signal light
If the warning lights will not turn off it could be the on and off switch. It could also be the relay switch.
in the back cargo area on the driver side is a switch behind a panel
There is no manual over ride for this except to clear the fault with VAGCOM, however if the fault is hardware and it is not rectified the warning light will return instantly.
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
There is a button type switch to the rear of the emergency brake, turn on ignition, starting car and hold button type switch. Light will reset. Also check air pressure on tires prior to above.
First you need to turn your ignition switch to the 'on' position. The You then need to connect the warning switch connector within 3 to 60 seconds.