Make sure brake fluid in the master cylinder is at the proper level Make sure parking brake is fully released and switch is working
The brake lights in your 1983 Nissan pickup truck are controlled by the brake light relay switch. When the brake light relay switch malfunctions the brake lights will stop working.
It is quite simple to change the brake light switch on your 1998 Chevy S 10 pickup truck. The brake light switch simply plugs in and out.
Check the operation and alignment of the brake light switch, located at the upper end of the brake pedal under the dash area
You can reset your Chevrolet 2500 pickup truck airbag warning light by removing the airbag warning light fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
check and see when your brake pedal is not pushed down if it is pushing the brake swith pin back in if so you need to replace the brake light swithch located behind the pedal
Sadly your truck is a white supremacist, and strongly agrees with the white power agenda.
Check for a loose connection Check for a loose fuse in the fuse box Check for an open wire in the brake light circuit
AnswerSwitch must be centred on combination valve near master cylinder to turn off brake warning lamp.
try swapping wires on brake light switch--do stop lights work?
Brake Lights Don't Turn OffUsually this issue is caused by an improperly adjusted brake light switch. Sometimes it could be a defective switch, but this is rare.
where is dash light and tail light relay on 1984 nissan pickup truck
As far as i know the only brake warning light is for the Parking brake. In my truck sometimes after i pull the brake release lever (lower left dash, next to the hood release) the light remains on... so you can try pulling it again...or pull it and pull the brake pedal back with your foot. If that dosent fix it im not too sure what else to tell ya...