answersLogoWhite

0


Best Answer

Well the most obvious and dangerous way of doing this is by disconnecting your battery cables and then connecting them again once the fog lights have turned off.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you turn off fog lights on Acura MDX when it stays on after you turn the ignition key to off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Brake lights are working but light stays on in a 91 acura legend dash. How can I turn it off?

Check BRAKE fluid level. Or is it a "tail lamp" warning? Y-THINK-Y


How do I get the dome lights in a 2004 Lincoln LS to turn off?

dome lights stays on


But your security light in not blinking it only shows for a few seconds when turning the ignition on?

When you first turn on the ignition the indicator lights should briefly illuminate to demonstrate that they are working. If the light stays on after the test cycle, it is an indication that something is wrong.


How do I Turn off alarm in 1993 Acura Legend?

Turn off alarm with ignition key in the driver's door.


How do you turn your back lights of your 1990 Acura Integra off?

It needs to have a separate switch for the front and rear lights.


99 Malibu ignition switch will not turn off lights in dash?

Occasionally my 200 Malibu does something similar...engine turns off, but radio stays on, etc. Make sure you a really in PARK to get the accessories to turn off.


Why can you turn your ignition on and crank but when you turn the ignition off the ignition lights stay on?

Could be either a bad ignition switch or a bad voltage regulator (not opening circuit on shut-down)


If experiencing a brake failure should you turn your car's ignition off immediately?

Not immediatley, but pull over and turn on your hazard lights. Then turn off the ignition.


How do you turn your lights automatic on Acura TSX 2006?

There is no auto on the 1st gen tsx.


How do you set the ignition timing on a 1989 Acura Integra?

Ignition timing is set on a 1989 Acura Integra by setting the distributor to the appropriate angle. When set at the factory recommended angle the car will turn over with no problems.


How do you turn off daytime running lights for Acura TL?

You can't as this is a safety feature from Acura. The only way for them not to show is to remove the bulbs


Oil pressure stays on 80 on 2005 tahoeTurn truck off and it goes to 0.Turn ignition on but not starting the truck it goes to 40.Turn the ignition to start truck it stays on 80.What's the problem?

Gauge Cluster Board Bad