By having the SRS repaired by a professional, who will reset the light. Do not attempt to repair yourself, as serious injury can occur when working on the SRS.
By having the SRS repaired.
fix airbag fault & serv light will go out
If the turn signal bulbs light but will not flash, the flasher relay is defective, replace it.
To reset your airbag light, in a Nissan Altima, you should turn the car on. From there, as soon as the airbag light stops flashing, turn the car off instantly. Repeat this three times to reset the airbag light.
If the airbag light is on, there is a defect somewhere in that circuit. You turn the light off by isolating and fixing the defect. Start with the fuse box.
That is illegal.
To turn off the airbag light you need to give a firm, well placed punch to the person nearest to you.
Check the airbag ring wiring behind the airbag. does it turn on when you turn the wheel?
The airbag light stays on when the computer detects a malfunction. The problem will need to be repaired before the light will turn off.
When the airbag light comes in in a car, it means that there is a problem with the airbag. In order to get the light turned off, one must take it to a technician.
Take the 1992 Toyota Camry to receive a diagnostic test. The machine will allow the test to manually turn of the airbag light and also see what is causing the light to turn on.
i installed a radio w/ harness and the airbag light is on, how do i turn it off or reset it?
Turn on car but do not start wait until airbag light gos out, turn off car before it starts to flash. do this 4 times
press the door light switch 5 times with ignition key on position . then turn of the key .(driver side door)
Check under recalls.There may have been a recall on this problem. The airbag controller has detected a problem. The airbags or an airbag may not deploy when called upon.
The light is on because there is a problem with the SRS. Have it repaired by a pro, and he will turn off the light.
Could be the interior light switch on the dash is turned on or the door light switch is broken.
For the airbag light to turn off, you'll need to repair the cause of the airbag malfunction, or disable the airbag by using a BMW scan tool or other software.
check your fuses or re-connect the airbag
use ignition key in passanger sideof the dash with door open to turn airbag on the light goes out
It is important to take care of the issues that have caused the warning lights to turn on. An airbag light can be reset by clearing the code with an OBD scanner.
The airbag light stays on when the computer has detected a malfunction and set a code. The failure will need to be repaired before the light can be reset.
Look in the instruction manual!
Turning off the airbag warning light on a vehicle is unsafe. The light is on for a reason, either a bad sensor, or an issue with the airbag. Either way, you should bring this in to a mechanic to have it looked at.
You need to have the code checked and the cause of it repaired to get the light off.