The following steps must occur within first 60 seconds of ignition switch being turned to ON or START position. 1) Turn ignition switch to OFF position, and buckle the driver's seat belt. 2) Turn ignition key to theACCESSORY/RUN position, and wait for the Seat Belt Warning Light to turn off. 3) Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver's seat belt at least three times within 10 seconds, ending with the seat belt buckled. 4) Turn the ignition key to the OFF position. A single chime will sound to signify that you have successfully completed the programming. The seat belt light will remain lit when belt is not fastened, but chime will not go off. To reactivate chime, repeat procedure 1-4 above.
2.4L has a timing belt. 3.7L has a timing chain.
The Jeep 3.7L has a timing chain.
The 2004 jeep liberty weighs about 3,800 lb.
90,000 miles. 144,000 km
A 2004 Jeep Liberty uses DOT 3 fluid.
A 2002 Jeep Liberty has a timing chain.
the 2004 Jeep liberty holds 19.5 gallons (73.8 Liters) ----
What fuse number for 2004 Jeep Liberty blower motor?
yes
where can i find a timing chain diagram fo 2004 jeep liberty
A 2004 Jeep Liberty uses DOT 3 brake fluid.
I have a 2004 jeep liberty and a dtc of p0441 comes up