The Enhanced Warning System (BeltAlert) can be enabled
or disabled by your authorized dealer or by
following these steps:
NOTE: The following steps must occur within the first
60 seconds of the ignition switch being turned to the ON
or START position. DaimlerChrysler does not recommend
deactivating the Enhanced Warning System
(BeltAlert).
1. Turn the ignition switch to the OFF position and
buckle the driver's seat belt.
2. Start the engine and wait for the Seat Belt Warning
Light to turn off.
3. Within 60 seconds of starting the vehicle, unbuckle
and then re-buckle the driver's seat belt at least three
times within 10 seconds, ending with the seat belt
buckled.
NOTE: Watch for the Seat BeltWarning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt.
Put your seat belt on:)
Put on your seat belt and buckle it up. The chime will then stop.
Buckle the seat belt around the back of the seat
look under the drivers seat and passenger seat and there should be a wire coming off the seat belt that you can unplug to stop the chime.
Ask your dealer
The seat belt electrical connection under the seat maybe be disconnected or cut.
Put on your seatbelt!
Wear your seatbelt.
Buckle up your seat belt and the chime will go off.
You follow the law and wear the seatbelt.
Buckle up your seat belt and the chime will go off.
it tells you how to do that in the owner's manual in the back.