A visual notification that the alarm is in valet mode is the LED light is on solid. If the LED is on solid and you wish to make the alarm active again, turn the ignition "on" then, press and hold the valet/programming switch for two seconds. The LED light will turn off.
If the LED light is not on solid then, the issue may be with siren itself.
If you have a valet switch, just hold it in for a few seconds with the alarm off and release when it beeps or blinks the LED. You may be able to unhook the battery briefly to reset the alarm's status.
<p>try turning your key on and flip the valet switch, your alarm is most likely in valet mode (youll know cause the led stays on) if that doesnt work, turn the key on and off then toggle thye valet switch 3x and that'll turn off silent mode. contact@adrianbarascu.ro<p>
Just dont get ya car valeted ha
Put key in the ignition turn key to on/run position, then back 1 click to acessories position repeat 2 more times (3 total)
to set a alarm you just press the ''MODE'' buttion
The "Valet Mode" for car alarms is essentially an "off" switch, for the occasion that you let a Valet park you car, for instance at a fancy hotel, casino, or repair shop. It is basically to keep the alarm from going off while someone unfamiliar with how your security system works is driving the car.
Turn off the alarm by pressing the upper and lower buttons on the right side of the watch while it is in time mode.
What do you mean by "valet mode"? If you mean the trunk release button won't work, there's a valet switch inside the glove compartment that activates and deactivates it. Just turn it off. OR You use the black key in the trunk keyhole which is located in the xk8 emblem. The Keyhole is located between the x and k. That should take it of valet mode.
First, unscrew the bottom and switch the "mode lock" to ON. Press the "mode" button on the back of "Bob" until you get to the alarm. Then simply press and hold the Up arrow.
Hold the reset button when your on the regular time mode, and press mode to turn off alarm. You should see the days of the week disappear.
1. press mode (SP mode ON) 2. press mode (AL mode ON) 3. press start/stop (chime on & alarm off) 4. press start/stop (chime off & alarm off) 5. press start/stop (chime off & alarm on) 6. press start/stop (chime off & alarm off) 7. press mode (basic watch mode)
Go to the Alarm mode,you will see two symbols-One a bell (alarm) and another '' (signal) Press the button until the '' mode is not seen.