Not familiar with those vehicles but if you turn signal doesnt put twords you or away from you and locks in for high beam which is for most vehicles then check the floor some of the old models have a small round button on the left side of the pedals press that for high beams if not then there is a switch for it inside of the vehicle.
Trust points are greatly appreciated.
how do you turn on high beams on 1979 corvette
Pull the turn signal lever toward you to switch to high beams and back again Pull the turn signal lever toward you to switch to high beams and back again
Your headlights turn off when you turn the high beams on because you have a defective switch. You need to have a mechanic replace the high beams switch. It is a simple replacement.
You need to turn your high beams down and ,after the car passes, you may turn them back to high beams
Take your car in to have it checked. Turn signals should work without high beams.
turn it on
Should be like any other vehicle. (pull turn signal stick back (high beams on), pull it back again (high beams off).
ask this to the dumb mind of the dodge creator.
Pull back on the turn signal lever to change from high beams to low beams If the turn signal lever is pushed forward the high beams stay on and if the turn signal lever is pulled back all the way that is the " flash to pass " feature
It's possible that when you turn your blinker on you are inadvertently pushing the lever forward causing your high beams to come on and stay on.
high beams!
they had to use ropes