answersLogoWhite

0


Best Answer

You first put the car into either neutral or park (this will depend on whether the car is an automatic or stick (manual)), and then you start the car again. That's it! Good luck.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you turn your car back on after turning it off in drive when it won't let you shift gears?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the differential located on a Ford F-150?

The differential (rearend) is what your back wheels and drive shaft are bolted to. If you have a 4 wheel drive there is one at the front as well. The differential has a series of gears ( spider gears ) inside. This allows for the difference of the speed between the left and right wheels when turning corners or going over bumps ect.


How do you shift slk 230 kompressor?

By moving the shifter to the left will make the trans shift manually. So by slapping it to the left (sort of speak) will downshift it thru all the gears. Opposite for shifting it back up thru the gears.


What are the ratings and certificates for Drive - 2007 No Turning Back 1-4?

Drive - 2007 No Turning Back 1-4 is rated/received certificates of: USA:TV-14


How do you change from 4 wheel drive back to normal?

you shift


What BEST describes an automatic transmission shift valve?

An automatic transmission shift valve is like a swing. It is moves back and forth with the use of pressure. That is how gears are changed.


What causes a Murray riding mower from moving back and forward?

Depending on your transmission, assuming it is a gear drive and not hyrdo, the brakes could be locked on the unit, or it could be hung in gear, are you able to change gears using the gear shift ???


Why does it shift from overdrive to a lower grear and back With it not being undewr load?

One possibility is that your valve body in the automatic transmission needs to be rebuilt, or replaced. It's best to have it taken care of as soon as possible, because you may end up losing gears. Shift changes may become rough, or the transmission may not shift in or out of gears.


How do you use the 4x4 on 1991 Chevy Silverado?

I have a 91 also. For 4h i put the tranny in neutral even though you don't have to and then shift the lever to 4h then the tranny back into drive. For me it seems to activate faster if i put the truck in neutral instead of shifting on the fly. For 4L you have to put the tranny in neutral and shift from 2H to 4L quickly without stopping it in neutral otherwise the gears will grind. Once its in 4L you can put the tranny back into drive and your good to go.


Your 1995 Chevy blazer will shift down into the gears and back up but it wont go into park It stops between park and reverse with the gear shift up in park?

Align the shift indicator orreplace it. Your problem is strictly column mechanical.


Would a 1987 Chevy blazer fourwheel drive front pinnion gears work in the back axle?

I would doubt it. The gears are usually dimensionally different in the front and rear axles. NO!


96 Ford Explorer wont shift into gears?

If when you go to shift into drive or reverse it makes a slipping out (gears moving but not catching just grinding) make sure its out of 4wd or 4wd low ..... i had this happen to me just today. I went up a path in somewhat deep snow so i put it in 4wd somehow managed to turn in an extra click to 4wd low (only suppose to do that in while in neutral with your foot on the break) then while driving on the road tried to switch it back and the light stayed on and I got low speed due to it being low then when i stopped it must have went back to 2wd and the gears were out of place thus making it slip


What verbs could you use for car?

* accelerate * back up * change gears * crash * de-accelerate * fasten seat-belt * fill up with gas * idle the engine * park * pass * pass * push the accelerator * push the clutch * race * run out of gas * shift into drive * shift into reverse * slow down * speed up * stop