Want this question answered?
mamiya 7 and a bronica GS1
fault tolerance
I would trace cable and use vice grips. Cable is likely dealer only and expensive.IE: Find it and rig it!
my Beretta is a 94 and it hood release is broke just the silver cable show ,,, i use needle nose pliers and pull it !
Fault tolerance.
Use pliers and pull the cable...
This is kind of neat: The fiero comes with a second cable already installed. Remove the hood release handle and there should be a cable end hanging there. Pull and release the hood. The replacment proceedure is undo damaged cable from hood latch, tape the new to old, follow the camle to the bulkhead and release all the hold down clips and gromits, use the old to fish the new through the car, re-conect.
Yes - we use the factory cable
use the gas tank to masturbate and ejaculate in the engine
No, you can use the VIDEO cable instead and just let the S-CABLE hang loose but the S-Connector/Cable will give a better picture so use it if you can.
I don't know about Silverado trucks but all of the emergency (parking) brakes I'm familiar with use the brake cable to "pull" and hold the brake against the drum (or disk), so if the cable breaks you simply cannot apply the emergency brake. That is, it is automatically released if the the cable breaks.
That depends on a few things. If the cable has broken at the release handle, you can use Vice Grips or pliers to grab the end of the cable and pull. If the hood is stuck down you can have a helper pull up on the hood while you work the release in the car. If the cable has broken at the latch consult a pro for help. If you get a helper to hold the the hood release open on the inside and tap lightly, with the side of your fist, on the front of your hood just above the grill. This will usually work if the cable is not broken.