Buy some RV antifreeze (the kind that is safe for pets) and pour enough into the drain to ensure the piping is full back to the main body of water.
You may have to mix the antifreeze 50-50 with water.
If its not connected through the skimmer I imagine it's there to empty it. hmmm, on the above. The main drain in pools is for circulating the lower part of the pool and is not intended to drain the pool as in a bath tub.
Well, if you mean to drain the pool --- it is not a drain as in house plumbing -- the sink -- the tub. It is connected to the skimmer and that is connected to the pump. Your main drain is most likely 'working'. It does not nave to be a strong flow. Well, if you mean to drain the pool --- it is not a drain as in house plumbing -- the sink -- the tub. IT DOES NOT DRAIN ANYTHING. It is connected to the skimmer and that is connected to the pump. Your main drain is most likely 'working'. It does not nave to be a strong flow.
I put marine goop in the plug and put the cap back on tight,..you can remove the putty by using a srcewdiver to loosen it, it will pop right out!
If you look at the pipe that is going into the filter pump you will notice that it has a tee that is peceeded by two or three pipes comming up from the ground. Those will be from the skimmer, main drain, and if you have one from the cleaner. If you observe the flow of water in the skimmer then change the valve so there is no more water flowing that will be the one going to the main drain or cleaner. Repeat the process to eliminate which one is the cleaner. Which ever one is left is the main drain.
it is in a normal drain
Depends how the pool was plummed. If you have a dedicated main drain line, or you share a main drain line and a skimmer line. Both are suction lines to the pump,meaning they will go into the front of the pump. If you have several valves on the front of the pump, and hopefully they are labeled you could try to shut all of them except the main drain and use what is called a drain king. It hooks to a waterhose and swells inside the pipe forcing water in the opposite direction. If you dont have any valves on the front of the pump ,chances are you share suction with the skimmer. check the inside bottom of the skimmer. Main drain may be plummed to skimmer bottom.
Cut into the existing drain where you feel it would help the most and run a vet to the outside, preferably to above the roof line. At the point furthest from the main drain.
With the onset of the cold weather, you will need to winterize your gunite pool. Backwash the pool filter. Detach the pump and filter to drain any left over water. Drain the pool heater. Remove return jet fittings, the skimmer basket and pipes. Blow air through the system until bubbles appear in the water and cap off the fittings. Put an empty twenty ounce plastic bottle in the skimmer basket to compensate for freezing and thawing. Remove water from the main drain line and cap it. Remove ladders and floats. Lower the level of the water beneath the tile line.
Well there is the pollen, stem, nectar, petals, leaves, I don't know if this helps.
If you mean you are losing water, it may be a broken or cracked main drain or possibly your hyrdo-static valve is malfunctioning. One other possibility is a break in the pipe going to the main drain.
There is usually some space around the drain hose where it goes into the drain. This usually allows enough air to get in that it is not a problem. If the washer hose is connected to the drain tight, then yes, there needs to be a vent above that connection. There may already be one above the drain if you follow it up. Most washer drains are fairly close to the main stack which allow for venting. The only question is, Does the washer drain alright? If so, don't worry about it.
Current flows from the voltage source to ground. If an appliance is not grounded somehow the hot were to touch the metal case and you touched the case while standing on the ground then the current would try to travel to ground through your body. I once was called to debug a situation in a residence in Florida where the owner got a shock everytime he took a shower. Turns out the main electric panel had never been grounded to earth and thus the whole house was floating above earth ground. Essentially all the metal pmumbing was at about 60 volts above ground. When taking a shower the water stream conducted the current through the owner's body to the metal drain which was earth grounded.