answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you wire 1987 bronco 2 for towing?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the towing capacity of a 1989 ford bronco 2?

stock bumper hitch is class 1 @ 2000lbs


I have a 1988 Ford Bronco and the headlights won't come on. Any ideas on why?

ground wire 2 frame


No power to fuel pumps on 1987 bronco 2 what could cause this?

no power is either a broken wire or a blown fuse Assuming battery is fully charged, check fuses or relays. Most cars have a separate relay for the fuel pump.


Will a 1988 FWD bronco 2 transmission fit a 1987 2wd ranger?

no the transmissions are different and it wont work.


Why does my 1987 ford bronco 2 idle for 5 to 10 seconds then die?

Check the TFI module. It is located on the distributor.


How do you reset the computer in a 1988 Ford bronco 2 has new battery and still no power?

the bronco needs to have the ground wire connected from the battery to the body. if you replaced the battery and disconnected that ground it simply won't start.


Why does your 1987 Bronco 2 jump and then die when you put it in drive or reverse?

I would check the idle air solenoid on the intake manifold


What is causing a rattling noise from the transmission or clutch of a 1987 ford bronco 2?

probably the through out baring or ur trany is goin out


Can someone post the diagram for a stock stereo on a 1987 bronco 2?

I got mine from here: http://www.installdr.com/Harnesses/Ford-Wiring.pdf


Where is transmission check plug on a 1987 ford bronco 2 with the mitsubisihi transmission?

large bolt head located on drivers, side of transmission.


Where is the O2 sensor located on a 94 ford bronco?

I am pretty sure there are 2 of them. They are on the exhaust near the engine and on the catalytic converter. Look for a single wire.


How do you install a starter on a 1985 Ford Bronco II Eddie Bauer edition?

I have a 1990 bronco 2, but i just had my starter rebuilt. it was relatively simple. its located underneath the engine. sort of close to the cab. but there are two bolts that connect it to the bronco. then there is a bolt that connects a wire to it. first disconnect you battery though