Your amplifier should(hopefully) have an input for a "remote turn on" or some words to that effect. Hopefully your deck has either a "remote turn on" wire or a "power antenna" wire coming out the back of it. If it does, you're in business. Extend it to the "remote turn on" on the amp and you should be good!
The problem you're having is an easy mistake. The wire you're connected to is not the remote wire for an amp. This wire you're connected to is used for a power radio antenna. That's why it's turning off the amp whenever you leave the radio.
if you are talking about an aftermarket radio's amp turn on wire then without an amp you can just cap it off. if the harness used to connect to new radio to your factory wires has a blue antenna/factory amp then you can connect it to that provided the new radio doesnt have a second blue wire for that purpose.
radio broke see car dealer
Yes a remote wire is necessary. You must wire the remote wire from the amp to and ignition source of power (a component which turns on when the ignition in the car is engaged.) i.e. the radio. The remote wire signals for the amp to power on.
Turn your radio off before you shut your car off.
P.CONT is a turn-on lead wire for your external amps if you have them. All it does is sends a signal to your amp (if you have one) to turn on/turn off
Your radio must be poorly installed in your car for you to reset your stations every time you turn your car off. A car radio ultimately rely on 3 wires for it to function properly. 12 volt wire- Gives Continuous Positive current to radio. Saves your settings, and Saves your stations when your car is off and on. Ground wire- Gives Negative current to radio. Work with the Positive current going to your radio coming from the 12 wire. Without this wire connected, your radio wont function at all. Accessory wire- Will only provide Positive current to radio when the car turn ON. This wire is used to make sure the radio will turn on with your car. The reason you have to keep resetting your stations every time you turn on your car is because someone connected both 12volt wire and Acc wire that's from the radio into the Acc wire in the car. There's no continuous positive current going to the radio when the car is off because the 12volt wire in the car was not used. I'm a professional MECP Certified Mobile Electronic Installer. Let me know if you are confused or have any more questions regarding your audio system.
you need an amplifier first. decide where you want the amp, and wire it to that point. (amp comes with instructions for the wiring) once the amp is wired in, wire it to the radio(instructions come with amp) and screw it in. then locate where you want the sub(s) and wire it to that from the amp. almost all your instructions for installing subwoofers comes with the amp.
splice the blue amp wire on the harness to the power wire, your car came with a factory amp. that will give you sound.
The remote wire is not hooked up. It should be a small blue wire, just take the radio out and hook thise remote wire up and then the radio should turn off when the car is turned off.
It runs from your deck to the amplifier. When the deck turns on, it sends a low voltage signal to the amp to let the amp know to turn on. If you are running an amp on a stock stereo, there are other ways to turn the amp on without a remote wire, but that's the easiest way. So, simple answer, it turns your amp on when the stereo comes on.
remote wire is to control amp, bass coming from subs, and the frequency