0
Basically you start your bike up and you should be in neutral, pull in the clutch lever. If its a bike usually u push down on the shifter which should be on your left next to your peg. If its an ATV u click it up now at this point rev your bike to around 1/4 the throttle then, very slowly let the clutch go and you should move forward ( It takes a couple of times ) meanwhile pull the throttle to about half way if you feel like your bike is getting loud, pull in the clutch and click your shifter up, you should be in second gear now, unlike when you were in first gear, let go of the clutch completely, your clutch is now fully engaged and if you're pulling on the throttle you're probably accelerating (If your not your bike has some problems). Repeat the process if you would would like to keep going faster. If you would like to stop I suggest you pull in the clutch and shift into first gear and use your brake until you come to a complete stop ( Or one or two mph ). If your stopped give it the same process as stated above. If you would like to slow dorw only slightly just pull in the clutch and don't touch the shifter ( This is best used for turning ).
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Why wont your clutch work?
my clutch went to the floor what happened?
Is there clutch fluid like for a transmission?
Transmission fluid will do work for your clutch my friend no worries here.
How does the clutch work?
An explanation on how a clutch works in a car is to transfer power from the engine to the gear box.
How can you adjust the clutch on a 2004 Kia Optima?
All the newer cars have self adjusting clutches that are hydraulic, they work on the same principle as disc brakes, as they wear the pads keep getting closer to the rotor or as in your case the clutch disk.
How do you tell if slav unit that engages clutch is bad?
clutch wont work will also leak fluid
Why would you have to pump your clutch pedal several times to get the clutch to work on a 1997 Honda accord?
you could be low on clutch fluid, air in the lines if a small leak in the lines or your clutch is going bad
Why wont my clutch lever work on your Yamaha blaster?
Well cable could be froze up. Replace the clutch cable. If cable is working adjust cable. If the clutch cable is adjusted then it's time for a new clutch
Why does the clutch on oblivion in Alton towers don't work?
It doesnt work because oblivion has been running for a long time in alton towers and the clutch has now been over used so i doesnt work
What can the problem be when a 91 Nissan sat for a long time and the clutch pedal is stuck to the floor?
check your clutch fluid lines and your clutch fluid and also bleed the clutch and it should work just fine mine did the same thing and i had to replace a clutch line that was pinched
How does steptronic transmission work?
manual transmission , with no clutch pedal .
Does 86 clutch cable work on 87 mustang?
yes
Where is the clutch fluid in a 96 Nissan 200sx?
The '96 200sx has no fluid for the clutch. This car has a cable operated clutch that needs to be adjusted. If the cable breaks the clutch will not disengage. If the clutch is getting tight it will need lubed. If lubing the cable doesn't work a new cable is needed.
