0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are signs of a faulty mass air flow sensor in my 94 grand marquis?
Rough Start, Low power will feel like car is starving for fuel. Unplug the mass air flow sensor and start car it should go to default mode and if it runs fine you have a bad mass air flow sensor.
Why wont your 91 300zx go above 2500 rpm?
run ecu codes, your Mass Air Flow Sensor is probablly bad or dirty
Where does the intake air temp sensor go on a chevy malibu 07?
Should be on the air intake just after the mass air flow sensor. From the Air filter, you have a cover with a big fat rubber hose, then the big metal square Mass air flow sensor, more hose and on the side is the intake air temp sensor then the throttle body assembly
Location of mass flow sensor 1988 regal will check light go off if maf sensor dis-connected?
No. Wish it were that easy to get that darn light off! Make sure you have code checked to see that it is actually a bad Mass Air causing the light to go on. Many things can cause it.
Would a rear end accident cause the mass airflow sensor to go bad?
It is definitely possible that being rear ended can cause the mass airflow sensor to go bad. If the exhaust system has been damaged, it will effect the airflow. Also the impact itself may have jarred the sensor loose.
How much money for idle valve replacement on Ford Escape?
$79 if you do it yourself. It only takes 2 bolts and it sits on top of the intake manifold. Five minute repair if that is what you need. Go to your local auto parts store and buy it. Unplug the old one, remove the 2 bolts holding it on, install the new one, you're done. An easy, but always accurate test of the Idle Air Control valve is to just unplug it while the car is running. IF the car wants to die then your sensor is fine and working, if you don't notice any difference then the Idle Air Control valve is most likely bad. First make sure that is what you need. It could be a Mass airflow sensor if you are having problems with it not running good at idle. A bad Mass Air Flow sensor will make it stall at idle, shift bad, no power at take off. Usually a bad Mass Air Flow sensor can be cleaned using Mass Air Flow sensor cleaner. $6.99 a can vs. $100 to $200 or more for a new Mass Air Flow sensor
What causes the mass air flow sensor to fail?
sometimes oil or dirt can cause them to fail. other times they just go bad. they make a mass air flow cleaner spray,don't know how affective it is, has to be a very dry cleaner,meaning not oily solution.
Where is the mass air flow sensor in a 2003 Lincoln navigator?
In a 2003 Lincoln Navigator : ( the Mass Air Flow Sensor is between the engine air filter and the big engine air intake tube , it is INSIDE the round plastic housing , you will see where the wires go into the bottom of the housing )
Where is the mass air flow sensor on a 2000 Sentra 1.8l 4-cylinder?
The mass air flow sensor on the Sentra model is a small piece that is inside the air duct tube fastened with two special torx screws, just after the air filter. After that, the duct continues to travel toward the throttle body, which then lets the air go inside the engine. You can remove a section of that tube which houses the mass air flow sensor.
Where is mass air flow sensor located on 2002 ford escort zx2?
On a 2002 Ford Escort ZX2 : The Mass Air Flow sensor is between the engine air filter and the engine air intake tube . It is INSIDE a round shaped plastic housing ( you will see where the wires go in )
Where is the mass flow sensor located on a 2003 Lincoln navigator?
On a 2003 Lincoln Navigator : The Mass Air Flow Sensor is located between the engine air filter and the big engine air intake tube . It is INSIDE a plastic housing , you will see where the wires go in at the bottom of the housing
Where is the mass airflow sensor located on a 2001 ford winstar se sport?
On a 2001 Ford Windstar : The Mass Air Flow sensor is INSIDE the round shaped plastic housing between the engine air filter and the engine air intake tube * you will see where the wires go into the bottom of the housing
