The electric switch heater uses high voltage, from 480 to 750 volts, through coils that are fixed both on the web of the rails and with "crib heaters" that are laid underneath the movable rods between the ties.
These are typically more effective than other types of switch heaters because of the ability to provide the crib heaters, which cannot be used with gas heaters.
The heating elements are provided throughout the area of the movable parts of the switch layout.
Electrical energy converted into heat by high electrical resistance
Yes, an electric baseboard heater can be installed under a towel rack in a bathroom.
Only if you leave the burners or elements on. -If water stops, close gas line or switch off breaker for tank.
There are two types of thermostats. One is a line voltage stat. This is in effect a switch and when turned to the off position the voltage is interrupted and the heater will not operate. The other type of stat is low voltage. There will be a relay in the baseboard heater that the thermostat is connected to. With this type if installation to turn the power completely off you will have to turn the breaker off that feeds the circuit.
A switch
copper?
They work about as well as a space heater.
I posted this question before I registered. Here's an amplified version of the question: I have an electric floor mat heater that gets too hot. I've found a good dimming device made primarily for incandescent lights, one that uses a triac unit for reducing the electric output. Would this work well for my heater?
No, an electric appliance will not work without electricity.
Your heater switch may not need to be replaced. The heater high position is controlled by a fuse under the hood. Until you find the fuse and replace it, your new switch will not work. JRR.
No, and this is a very good energy saving practice.
the thermostat used to control the heater and after we select the four pole switch to some number the thermostat start connect the power to the heater at the same time the heater start to heat and when we select the switch to zero position the heater not work
it's more than likely the switch for the heater.
electric heater
did your heater switch go out all of a sudden or did some work like high work and low not work? if some worked your blower resister is most likely bad under your glove box
Heater Blower Resistor
There are usually 2 on a domestic electric heater, one about a foot from the top and the other near the bottom, both attached to the elements.
check the fan switch.