0
How does auxiliary drive belt tentioner work on mondeo tdci mrk3?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where can you find tentioner of Buick Skylark?
The lower part of the drive belt runs around the tentioner. It's where the adjustment is made to tighten or loosen the belt.
How to change drive belt on Ford Mondeo v6 1998?
by hand
How do you tighten belt after replacing automatic tentioner on 1995 Chevy lumina 3.1L?
I have put the new automatic tentioner on but, I can't seem to get the belt tight and keep the tentioner in its proper grooves.
What are the possible causes of my mondeo diesel engine becomming noisy when ideling?
Mk3 Mondeo diesel 2001 onwards were built with defective crankshaft pulley which drives the large serpentine auxiliary drive belt. at idle speed it rotates slightly off centre which sets up oscillations in the drive belt causing major resonance. The loud drumming sound disappears when revs reach 1000rpm. ford service bulletin issued to replace pulley with revised item and also replace belt and belt tensioner.
Do I need a special tool to replace the serpentine belt on a 2005 pacifica?
No The tentioner should have bolt in center move tentioner to apply belt
Is there an alternative belt tensioning method for tensioning the drive belt on your 95 grand Cherokee L6 The tension gauge is rather costly?
replace the belt not the tentioner also cost much less
How do you change belt on 96 mustang gt power steering?
Use a 3/8 drive rachet to push down on the belt tentioner it goes right in the tensioner,,While holding it down remove the serpentine belt.
How do you replace fan belt for 1996 GMC suburban?
To replace the drive belt on a '96 Suburban you have to release the tention on the tentioner pulley with a wrench or socket. Once you get the belt off of at least one pulley you can release the tentioner pulley. Remove the belt the rest of the way. To re-install the belt follow the routing guide under the hood. To get the belt all the way on you'll have to release the tentioner on the pulley again to get the belt all the way on. Once the belt is all the way on release the pulley and inspect the belt to make sure it's all the way on all the pulleys. Remove the wrench or socket and you're done. Hope this helps, good luck.
Is the auxiliary drive belt same as timing belt?
The simple answer is no. The auxiliary drive belt or belts run your auxiliary systems (IE AC, Power Steering, Alternator). The timing belt runs valve timing (it keeps your crank shaft and cam shaft or shafts running in time). PS. If you have a timing belt, you have an interference engine. Therefore the timing belt MUST be changed every 60,000 miles to avoid destroying one or more of your valves (top end engine rebuild or worse).
How do you change belts on a 1991 Ford Escort?
lossen belt tentioner
How do you replace the belt when installing a water pump in a 1989 Suburban?
This should be a serpentine drive belt. If you havn't removed the belt yet make a sketch of how the belt goes over the pullys. Most vehicles now have a drawing somewhere under the hood. The tentioner for the belt is on top and requires a 5/8" or 15mm wrench to pull the tentioner away from the belt. remove the old, install the new. Pull the tentioner away as far as you need to slip the belt into place. Visually follow the belt all the way around to insure it is in place before starting the motor. HTH Stan If you dont have a belt routing drawing to install the belt go back to your parts store and look in the belt catalog. They have pictures for most all vehicles. Stan
What causes the power steering to go out and the red battery light to come on?
The auxiliary drive or serpentine belt (not timing belt)being lose or snapping
