answersLogoWhite

0


Best Answer

You have to reach in through the fuel filler hole, either using needle nose pliers, forceps, or a bent piece of wire to pull the fuel line through. There is no easier access. If you remove the air filter you will have a little more room to work at it from the other end too.

http://store.chainsawr.com/

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How does one get to the gas tank to replace the fuel line to the bulb for my Poulan 2150 chainsaw?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the primer bulb on the snapper S31SST weed eater?

www.odref.com/poulan/pdf/snapper/all/s31sst.pdf


How do I replace a cracked primer bulb of Eager Beaver 2014 chainsaw?

Check with Ebay, I found one there.


Need a full diagram for fuel line routing for a poulan 2150 chainsaw?

There are two lines inside the tank. The short line with no fuel filter on the end of it goes to the inlet, (suction) side of the primer bulb. The long line inside the tank, with the filter on the end goes directly to the fitting on the side of the carburetor. The line, inside the air box from the outlet side of the primer goes to the remaining fuel line fitting on the carburetor. http://store.chainsawr.com/


How do you replace poulan chainsaw fuel line?

I'm having the same problem with my Poulan chainsaw and weed eater. I think the line starts with the fuel filter in the tank and travels up to the primer bulb, out of the bulb into the carburetor, and out of the carburetor back to the tank. Whatever the size of line is that hooks to the fuel filter is what will hook to the primer bulb and then the carburetor. Then one more single line returns to the tank. I may not be correct on this, but there's not much information available. The diagram on Poulan's website does not show the routing of the fuel lines. that is right but to remove the main line you need to drain fuel and pull the line out from the fuel tank neck first because it has a connection that will not fit threw the hole in top. to replace it cut new line at a slaint and fir it threw from the top down into the fuel tank. then keep it long and pull out enough threw the fuel cap to put fitting back on it and fuel filter then pull it back threw and hook it to primer bubble. Not sure about your answer I have two different size fuel lines on mine. The larger line if I remember correctly runs from primer bulb to the right of fuel tank where the larger opening is located. The smaller line is where I am confused at shouldn't the smaller line from the fuel tank that has in tank filter attached run up to carburetor. then a smaller line from primer bulb to second fitting on carb. byrumjr the line starts with the fuel filter in the tank and travels up to the carburetor out of the carburetor into the primer bulb, out of the primer bulb back in the tank


How do you replace poulan chainsaw primer bulb?

Take off the cover on the left side of the saw that holds the pull cord. You should now see the plastic base of the bulb, with two Allen-head screws holding it in. Take out the screws and it should come out, still attached to the fuel lines. You may need to use very long, fine needle-nosed pliers to take off the fuel lines. Reverse all this to install the new one. You can buy a new bulb over the internet, but your local small engine repair shop can probably sell you one cheaper (and faster). Hope this helps.


How do you replace the license plate light bulb on a vw?

Remove the screws from the lens covering the bulb, pull out the bulb and replace it.


Replace stop light bulb on 2006 Colorado?

How do it replace the stop light bulb


How often should you replace a headlight bulb?

Replace headlight bulb only when blown.


How do you replace a front indicator bulb in a Saab 9 3?

How do you replace a front indicator bulb in a Saab 93


Honda CR-V replace side marker bulb?

To replace a side marker bulb on a Honda CR-V, open the hood and remove the small screw on the back of the bulb. Pull the bulb forward and it will come out easily. Replace the bulb.


Can you replace a PC 168 bulb with a 168 bulb?

no


How do you replace a Cadillac bulb?

need to know what bulb. The check engine bulb