0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How does one remove a peugeot 407 headlight?
you have to take the bumper off to get to all the bolts
How reliable is the Peugeot 407?
The Peugeot 407 estate is considered fairly reliable. Although this car is reliable, the car itself isn't as aesthetically pleasing to the eye as one might hope.
How reliable is the Peugeot 407 estate?
The Peugeot 407 estate is considered fairly reliable. Although this car is reliable, the car itself isn't as aesthetically pleasing to the eye as one might hope.
How does one lift the bonnet on a Peugeot 407?
, u can lift the bonnet of Peugeot 407 by unlocking from the inside of ur car at the left side , passenger side , the u go and lift it normal
Air condition clutch stuck on peugeot 407?
pumps go down quite often, new one required
Where is the fuel filter on a peugeot 407 2.0 hdi?
its on the right hand side, top on engine, under all the air pipes, there is a fair bit to remove to get to it. when you get the new filter you have to swap a part off the old one to the new one too
How do you replace a 1996 Chevy capric classic bumper?
Remove the bumper and put on a new one :)
What is the recommended tire pressure for a 2006 peugeot 407 sw?
Check to see if there is label on one of the door posts or fuel filler door
How do you replace a front bumper 1999 Toyota 4Runner?
buy a new bumper, remove the old one, and attach the new bumper
How do you replace a 99 Pathfinder front bumper?
remove bumper, replace with new one.....easy huh ?
How do you remove a Peugeot 407 stereo?
Its a while since i did one, but im sure its either just radio pins that you pop it out with or there are sometiny torx screws you have to remove first. either way there wioll be some small square holes around the front of the radio, that's where you put the pins in or take the torx out.
How do you remove bumper from X type?
First remove the bumper under tray, then remove the front of both front inner wheel liners. Then there is one 10mm bolt on both lh and rh sides behind the bumper above both front merker lights. Then remove the two 10mm bolts above both headlamp assemblies, and don't forget to remove the bumper slowly so that you can disconnect the bumper harness.
