answersLogoWhite

0


Best Answer

Drain it from the petcock on the bottom of the rad. Take off the cap to the resevior and radiator. Replace with Prestone green antifreeze 50/50 mix, not Dex-Cool. Follow burping procedure in manual.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How does one replace the coolant in a 1998 intrigue?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the freeze plug in a 1998 Oldsmobile intrigue?

you take the old one out and replace it with the new one... hope this helps


How do you replace a thermostat in a 1998 Camry?

Drain coolant, disconnect the battery. Disconnect the coolant line, replace the thermostat with a new one. Do not forget to replace the gasket too. Reconnect the line. Refill coolant, connect the battery.


Is there more than one coolant temp sensor on a 2000 intrigue?

No


When is it recommended you replace the timing belt for a 1998 Oldsmobile Intrigue?

The Oldsmobile Intrigue does not have a timing belt. It uses gears. For cars that do have a timing belt, about 60,000 miles. But remember than some engines don't use one.


How does one repair a 1998 cadilla catera coolant system?

To repair the 1998 Cadillac Catera coolant system, the steps will vary depending on the actual problem. You might need to replace hoses or connections or you might need a new radiator or thermostat.?æ


Does a 1998 Oldsmobile intrigue has a separate belt for power steering?

no there is only one belt


How many coolant sensors are on the 1998 dodge neon?

OneOne


How do you replace a thermostat in a 2000 Oldsmobile intrigue?

take out the old one then put a new one in the same way you got the old one out


Where is the fuse box located in a 1998 Oldsmobile intrigue?

There are two fuse boxes on a 1998 Intrigue. One is under the hood, on the passenger side near the battery. The other is inside the cabin. If you open the passenger door, there is a panel on the end of the dash. There should be a slot on it that you can get your fingers into then just pull it off.Hope this helps.


How do you replace the coolant sensor in a 1998 jeep grand Cherokee with the 5.9 moster engine?

if you are referring to the engine coolant level sensor located in the top of the engine coolant reservior (usually gives the message "coolant sensor bad" in the VIC when it is bad), it can be easily "popped" out of the bottle with no tools necessary and a new one "popped" back in its place. **mine is a V8 model this should hold true for the I6 as well


Spark plug firing order for 1998 Oldsmoble Intrigue 3800 v6?

The firing order for an Olds Intrigue is 1-6-5-4-3-2. The number one cylinder is on the drivers side, closest to the firewall.


How do you fix a leaking coolant holder on a 2004 grand am?

Replace the reservoir with a new or used one.