How easy is it to change the serpentine belt on a 1987 cutlass ciera and how is it done?
It's not hard. Just quite annoying getting everything in the right place. I had a hard time doing it around the air conditioner.
Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?
what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
with a spark plug sockett
I have 2 of these cieras and NO they are front wheel drive, the cutlass supreme is real wheel drive
HeyRyan==It depends on what engine you have. It will be at the rear of the engine on the bottom. Good luck Joe
Thermal relay is stuck. Replace it.
Remove the light assy with the mounting screws.
General rule is that you need 10psi for every 1,000 rpm's of the engine.
just follow the top radiater hose to it, it's almost always on top of the motor block.
What would cause my 1987 Cutlass Ciera to begin shaking and shut completely off when slowing down to stop?
brake booster has probably gone bad.
Seats from any other GM A-bodies (Buick Century, Olds Cutlass Ciera and Pontiac 6000) should fit.
There was a V-6 and 4-cyl. You can find your [http://autorepair.about.com/od/enginefiringorders1/Engine_Firing_Orders.htm Answer Here] Good Luck and Remember. Change Your Mind, Not Your Oil. Use the First In Synthetic Motor Oil's. See My Bio For more information.
the cam position sensor is just below the water pump pulley in the front timing cover. Master
re; replacing a starter on a 1987 cutlass cierra is very hard as the one in mine just went. it is best to bring it to a mechanic as the whole engine has to be jacked up and it is well over a 3 hour job. cost me around $300 that was with new starter and labor and it was worth it prices will vary wherever you live. hope that helps
The 1987 Oldsmobile Cutlass Supreme was rated 350 horsepower with the with the V8 engine. It was last year that the Cutlass was a rear wheel drive vehicle.
where is the emc located on a 1988 olds cutlass?
what size is the motor?
The starter is located at the bottom front of the engine. Look down in between the radiator and the engine. if all else fails, crawl under and look up, but wear safety goggles and use a good light.
it is under the dash below the steering wheel you have to remove the steering wheel to replace it I have a manual that walks you threw this if you like I could send you the steps via email my email is email@example.com
well i have a 1987 cutlas supreme and it has a 307
I recently replaced pulley on power steering pump by taking it to a local garage they have a special puller to remove it and press it back on the new pump cost about 10 dollars
Where's the relay for the electrical antenna of a 1987 Cutlass Ciera and how do you get the antenna to work?
The relay is located on the bottom area of the antenna itself. Most of the time the motors burn out, or the gear inside the motor strips out. If that's the case, replacing the whole assembly is the easiest fix.
The total capacity of the transmission is 10 qts. If you are just doing a pan service, use 6.5 qts. Macs Transmissions Houston, TX 281-743-1000
If it has spark and fuel I would suspect the MAF (Mass Air Flow) sensor has failed. If it has no spark, I would suspect the crank sensor has failed. If it has no fuel, I would suspect the fuel pump has failed.
No! a 1987 cutlass is rear wheel drive, the van is front wheel drive....wrong offset.
Depends on the engine
It's in the fusebox.
not from the factory
It is probably IN the gas tank. You will have to drop the gas tank to get to it.
The 1987 Oldsmobile Cutlass cooling system has a fluid capacity of 5.5 gallons. The cooling system fluid should consist of 50 percent antifreeze.
In the belt book at most autoparts stores have a diagram section for serpentine belt routing.
they stock 307 engine code "9" had 170 hp for 1987
rightside bottom of steering column
Engine rotates but will not start
It's a metric 200R4
The firing order for a 1987 Cutlass Cierra with a 2.5L is 1, 8, 4, 3, 6, 5, 7, 2. When you face the car the number one cylinder is on the front left.
It should be under the hood of the car.
Not unless you put on a air suspension.
inside the steering column accepts the key but I believe the ignition module is a small unit above the carburetor - square and about 1/4 inch thick. when the car chugs and stalls or just does not start replce this module. It may fail intermittently and is often overlooked. Occurs at about 40 to 45,000 miles in my experience.
Around 4200 + or - 10% Out of this 1100 were T tops
Assuming you're referring to the rear-drive G-body Cutlass, it could have either a 231 cid V6 or a 307 cid V8
The Oldsmobile Cutlass Supreme was an intermediate-size car produced by GM for the U.S. market. The Supreme sat atop the Cutlass line, beginning as a trim package and eventually becoming its own model name. The popularity of the Cutlass helped drive Oldsmobile to a million sales for the first time in 1978. More than half were Cutlasses. Production of the rear-wheel drive Cutlass ended in 1987. The last car to wear the Cutlass badge was… Read More
Any major brand 10w30 weight high detergent oil.
2,499 Oldsmobile Cutlass Supremes V6's were made. They had a 5.7L engine sourced from the Delta 88 and the Ninenty Eight Regency
81-86 are the same. 87 is the same as the 88 supreme classic. 87 grills will NOT fit an 86 without changing the entire header assembly.
Its kind of a pain. I just force it. Or move the alternator. Sorry .. that sucks.. but better than nothing. I find removing the fan shroud makes it SUPER easier.
Old age Frozen or misaligned pulley
A Hanes or chilton manual
Yes it will fit. Both cars are "G" body's