Pull tire, make sure to chuck tires on rear. Put jack stands under front. Pull brake caliper 2 bolts that go into housing and little bolt holding ABS wiring harness. Remove rotor & dust shield. Remove axel nut cover & axel nut. Remove 4 bolts from back of hub. Remove hub. Takes about 4hours to take apart, clean, install. Done it last week to mine both sides. Removing inner tie rod will help to rotate hub to use impact wrench if available.
What are the torque specs for a 2004 2WD Chevy Tahoe front wheel bearing assembly 5.3 liter engine
Open the hood and then examine the top of the headlight assembly and locate the two pins that can be pulled up and out of the assembly. Then rotate the headlight Assembly out of the front of the grille and change the headlight bulb...reverse the process
Drill it out and when replacing use a screw.
Chevy Tahoe remove front and rear speaker
3/8 Allen wrench socket
Here is a link to some good instructions. http://reviews.ebay.com/ebaymotors/Chevy-Silverado-4x4-Front-Wheel-Hub-Bearing-Replacement_W0QQugidZ10000000002536494
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
Open both front doors and remove everything from the firewall to the front seat. No joke.
All wheels stay on the side that there on now. move front wheels to the rear and rear to the front. Do not change sides.
Need to know what the question is.
36mm
my 1999 chevy tahoe 5.7 was located in front of the oil pan, and not above the starter as so many said it would be....