well heres one easy answer to that- Just cut the freakin cables in half and you have lost your energy!
It is turned into heat by resistance.
DC = direct current.
Fuses and circuit breakers are designed to open a circuit when an excess amount of current occurs, so as to break that flow of current.A circuit breaker or fuse.
The current will remain in a 220 volt circuit as long as the circuit load remains in the circuit and the circuit remains closed.
This is called a closed circuit. If current was not flowing, it would be open.
In a circuit, the purpose of a switch is to control the current flow to the load by opening the circuit (off) or closing the circuit (on). When the circuit is open, the is no complete loop through which the current can flow. When the switch closes the circuit, it restores the loop, and thus allows the current to flow.
No. Current does not get lost in a circuit. By Kirchoff's Current Law, the signed sum of currents entering a node is zero, which means that the current at every point in a series circuit is the same. Power may get lost, by conversion to heat, but do not confuse power, voltage, and current - they are three different things.
No. Kirchoff's Current Law states that the signed sum of the currents entering a node is equal to zero. A consequence of this is that, for series circuits, the current is the same at every point in the circuit.
A battery is rated to supply a certain number of volts. However, it actually supplies less, because they are "lost" as the current has to get out of the battery in the first place.(The battery has internal resistance)The amount of lost volts depends on the current being drawn:The less resistance a circuit has, the more current is drawn, because it's easier to flow.Example:If the circuit has little resistance, it draws a large current and the battery's internal resistance causes more lost volts.If the circuit has high resistance, it draws a small current and there are fewer lost volts.This is why when you short-circuit a battery (give it hardly any resistance to go through) it heats up and may explode. A large current is drawn and all the volts are used by the battery's internal resistance.
The current in a circuit is reduced to prevent the circuit from over load.
Current = (Voltage across the circuit) divided by (Total resistance of the circuit). The current is the same at every point in the series circuit.
In shortg circuit current is infinitive.
The current flowing in an electrical circuit.
DC = direct current.
Fuses and circuit breakers are designed to open a circuit when an excess amount of current occurs, so as to break that flow of current.A circuit breaker or fuse.
In a circuit , current is inversely proportional to the resistance.
Direct current circuit.
current mirror circuit produce more stability as compared to biased circuit.