answersLogoWhite

0

  • Flats and Tire Pressure
  • Isuzu Trucks
  • Honda Civic LX

How long does it take to change the lifters in an Isuzu pick up 4 cylinder?

User Avatar

Wiki User

βˆ™ 2009-08-13 07:28:29

Best Answer
Copy

i dont think they have lifters as it has over head cam or at least mine does. so no time at all. if its a rattling the rockers need adjusting

User Avatar

Wiki User

βˆ™ 2009-08-13 07:28:29
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

How long does it take to change a brake master cylinder on 306?

Master Brake cylinder replaced and lines bled-how long?


Will a 1994 305 cylinder head enter change with a 1994 350 cylinder head?

Yes as long as you change both heads.


What do you call a long cylinder?

A cylinder? A cylinder is still a cylinder regardless of how long it is.


How long can a car run on bad lifters?

it depends on the car


How long does it take to change a master brake cylinder on 99 Mercury Sable?

21 hours


Your corvette has not been started in a year when you did drive for a while its tapping?

It depends, but it could be the lifters. If you have hydrolic lifters, they will lose oil when they are not run and "collapse". It will take some running time for the lifters to refill with oil (not sure how long exactly - ten minutes?). If the sound goes away after a little while, it might have been the lifters.


How long does it take to change a head gasket on a 1994 6 cylinder Toyota?

i read seven hours


What is trumpet look like?

it is a long bronze cylinder-like item with a pull handle and buttons to change the noise


How long does it take to change the heater core in a 1994 ford tempo 4 cylinder with air?

4 to 6 hours


How long to change a Nissan 6-cylinder pick up timing belt?

Refer to (and understand) repair manual


Had a valve job done to a 99 Chevy Malibu Now there is no compression and a misfire on cylinder 2 If the bolts on the rocker arms of cylinder 2 are backed off half a turn they get full compression?

the lifter rods are two different sizes. Three long and three about an inch shorter.Pull lifters all the way up and drop rods in and you can tell where they go.


How long does a timing belt last on the Isuzu?

on average 60,000 miles


How long to change head gasket in Pontiac grandam?

depends on what engine the 4 cylinder should take a day if you have all the tooling


How do you change the air filter in a 2003 Honda Accord 4-cylinder?

Just the long back hose to a big black box and there will be 4 push clips that pop off the top and there is your air filter


How long does it take to replace a master cylinder?

it should not take more than 30 min. it's a fairly simple change over.


What is the knocking sound of your 1991 explorer you are wondering if it is the lifters or valves and what can you do to remedy this?

An engine that has had long intervals between oil changes and lots of miles, can easily develop stuck hydraulic lifters. This can be a loud clicking/ticking noise at the top of the motor.Try this: Change the oil and subsitute one can of transmission fluid for engine oil then change it at 1000 miles or less . It make take a few changes but if it is a lifter ( most common problem) it should improve. I hope this helps you. Mark


Vortec 5.7 lifters chatter all of a sudden after you had your vehicle jumped due to battery going dead?

The two are not causally related, however... sitting for a long time could result in both a dead battery and oil draining from the lifters.


Is too much or not enough oil will make the lifters rattle in a 2006 Pontiac gran prix gt?

Too little oil makes lifters noisy. Without enough oil the lifters can't pressurize enough to close the gaps in the valve train. Driving too long with the condition can make it permanent even after adding more oil.


What can i use to fix hydraulic lifters?

I don't know what kind of lifter problem you are having.But I have had stuck lifters and lifters that would not pump up.This is the way I've fixed them before, some people laugh at this, but it worksOil is not a Hydraulic Fluid, Now Transmission fluid is.( some what )O That's right were working on HYDRAULIC lifters.Now change your oil and filter, Put 4 qts. of oil and the rest transmission fluidback in. If you can drive it, then drive it a lot. If not then just let it run for along time. I promise it will not hurt anything. It's an old trick and it works.Or aneven better thing to do if you are sceptical is to use LUCAS engine oil treatment use a full bottle(1L) every oil change an if it doesn't lift it then go back to the 1st awnser


Do all snakes have long thin cylinder shaped bodies?

Yes, all snakes have long, thin, cylinder - shaped bodies.


What is the Volume in liters of a 100mm long by 50mm diameter cylinder?

The volume in liters of a 100mm long by 50mm diameter cylinder is: 0.196 liters.


How long does it take to replace the camshaft position sensor in a Isuzu Rodeo?

Not long at all should take no longer then 5 mins


If a cylinder had an oval base would it still be a cylinder?

yes it would as long as it kept its size


Can you replace a blown valve on the 2.8 V6 Isuzu without replacing the whole cylinder head?

yes the valve can be replaced, but the head has to come off to do it. as long as there is no damage to the head ,you just need to do a valve grind to reseat the new valves,and not replace the head with a new one


What is the homophone for a long cylinder?

pole, poll