0
For the engine about 30 seconds. You only need to get the oil pressure up and that happens pretty fast. For the transmission, it should be at operating temperature so about 3 to 4 minutes should be enough.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Does engine need to running when checking transmission fluid for a 2000 v70 Volvo?
Yes it does. The proper way to check automatic transmission fluid is to check it while engine is at idle.
How do you check transmission fluid in a Dodge Ram Pickup?
If your checking the level of the tranny fluid in an automatic you need to turn on the engine let it idle in park NEUTRAL and pull the dipstick.
Does a 95 dodge ram 1500 have to be started to check the transmission fluid?
The fluid level in an automatic transmission in a 1995 Dodge Truck should be checked at idle in Neutral with the engine at operating temperature.The fluid level in an automatic transmission in a 1995 Dodge Truck should be checked at idle in Neutral with the engine at operating temperature.
How do you check the transmission fluid level on subaru forester?
I want to check the level of atf temp in my subaru forester 2010. On checking the transmission fluid level, after the car was driven about 10 km and was put in each gear and setting the select level in the "p", do i have to turn off the engine or idle the engine before i check the atf level?
I got a 1986 Toyota corolla 2 bbl carb rwd doesnt want to idle at all where should i start already changed all vacuum lines?
Did you try checking the idle adjustment screw?
What should your scan tool read for degrees at idle on a 98 4.3?
From what I can tell from checking around the Internet, your scan tool should read 0 degrees at idle for a 98 GMC 4.3 vortec. If your scan tool is reading anything else at idle, you probably want to have your mechanic check the vehicle for loose or worn parts.
Why would a 1990 2.3 not idle and accelerate on its own up and down?
You might try checking you idle air control valve.
Why does your Chevy 4.3L V6 Cheyenne idle rough you have replaced plugs plug wires distributor cap and rotor?
I would recommend checking for codes before you do anything else.
How do you get the idle to go down in a 1993 Chevy z28 camaro?
The idle speed is computer controlled on a LT1 engine. If it is a little high, try checking for vacuum leaks.
Should a turbo diesel vehicle idle before been switched off?
With any turbo it is a good idea to let the engine idle briefly before turning it off. This allows the turbo to slow down before losing lubricant. If you don't let it idle it probably won't hurt anything, but over time it may cause the turbo to wear out faster.
What should a 300 6 cylinder idle at?
Idle should be between 500 to 750 RPM.
After operating a vehicle how long should the driver idle the turbo diesel engine before they shut it down?
3 minutes.
